Vicon VAX Server Micro Form Factor User manual

Quick Start Guide: VAX Server
Micro Form Factor
This sheet covers the installation of the VAX Server micro form factor. This system should only be installed by
a qualified technician using common hand tools and approved materials in accordance with the National
Electrical Code ANSI/NFPA 70, state and local wiring codes.
Unpacking and Installation
Unpack the unit and place it in the mounting location. Hard drives are preinstalled from the factory.
•Keyboard and mouse are included with the unit.
•Connect monitor(s) using the DP and/or HDMI ports (refer to figures above). DP to HDMI adapters are
included as needed.
•Connect unit to the network. Refer to figure above. The port is setup to procure an IP address automatically
using DHCP.
•Attach the power cord and power the unit on. It is recommended to use an Uninterrupted Power Supply
(UPS) to prevent data loss/corruption and/or drive failures due to sudden power loss.
VICON INDUSTRIES INC. TEL: [phone] FAX: [phone] TOLL FREE: 800-645-9116
24-Hour Technical Support: 800-34-VICON (800-348-4266) UK: [phone] WEB: vicon-security.com
Vicon part number
8009-8274-28-00
Product specifications subject to change without notice. Copyright ©2023. All rights reserved.
Vicon and its logo are registered trademarks and Valerus and its logo are trademarks of Vicon Industries Inc.
Front Panel Connections & Controls Rear Panel Connections & Controls

1. Log into Windows using default credentials (login: VII; password: 1234).
4. The first time VAX is launched, an initial Configuration
screen will display. Fill out all pertinent information,
including username and password. Once that is done, the
next time VAX is launched, a login screen will display.
Enter the username/password that was previously created.
3. Click on the VAX shortcut icon on the desktop. You can also go
to the Start menu and click on the VAX icon inside the VAX
folder.
Launching VAX
Quick Start Guide: VAX Server
Micro Form Factor
Valerus Manual Valerus Performance
Guide
Valerus/VAX documentation has been provided on
the system. A link is on the desktop. For the most
updated documentation, visit Vicon’s website at:
https://www.vicon-security.com/products/valerus-
vms/ or https://www.vicon-
security.com/products/access-control/vax-
overview/
VICON INDUSTRIES INC. TEL: [phone] FAX: [phone] TOLL FREE: 800-645-9116
24-Hour Technical Support: 800-34-VICON (800-348-4266) UK: [phone] WEB: vicon-security.com
2. Update VAX as necessary. Refer to Vicon’s website.
VAX Manual
Desktop Icon Start Menu