Videotel Wave To Play User manual

Packing List
1 - Wave To Play
1 - Owners Manual
2 - Mounting Screws
1 - 6’ Control/Link Cable
1 - 2’ Control/Link Cable
1 - 6’ Power/Trigger Cable For
Using Wave To Play as a Dry
Contact Switch
Wave To Play Owners Manual
d i g i t a l
Basic Operation of the Wave To Play
The Wave To Play can be used with our interac-
tive media players (VP71, VP71XD, VP72, VP90,
VP92, HD2700D and HD2700M+), with most 3rd
party media players and as a“dry contact”switch.
When a Videotel digital media player is
purchased and bundled with the Wave To Play
proximity sensor then the solution is preset and
ready to plug and play right out of the box. The
SD card has also been pre-loaded with 2 sample
videos: 000.mov (stand by or “attract” screen)
and 001.mov (plays when the Wave To Play
sensor is triggered). Simply follow the connec-
tion and le name instructions to trigger the
“sample video #1” by waving your hand over the
Wave To Play sensor.
Connections
The Wave To Play will connect to any of our inter-
active media players with a 4 pin I/O cable. This
cable can be made in any length up to 50’. Con-
nect the I/O cable to the back of the media player
and then to either jack on the Wave To Play.
When connecting multiple Wave to Play devices,
simply use another 4 pin I/O cable and connect
the additional Wave To Play as shown below.
Naming Files When Using SD/USB/LAN/FTP
Load 1 video per Wave to Play and 1 looping
“attract / welcome” video on your SD/USB (for
LAN and FTP - see VP90/VP92 manual). These
les will need to be labeled 000.mov (mov, mp4,
mp3, etc.), 001.mov, 002.mov, 003.mov, etc. The
video le 000.mov represents the video that will
loop endlessly until the Wave To Play is triggered.
When using 1 Wave To Play the le 001 is set on
the “File to Play” dial and video 001.mov will play
once when triggered. If a second Wave Device is
used, the dial can be set to 002 and video 002
will play once when triggered.

Adjusting Sensitivity
The Wave To Play has four sensitivity settings.
The thicker and denser the material you place in
front of the sensor, the higher the sensitivity
setting should be. The Wave To Play is capable of
sensing movement up to 3” through wood, plas-
tic or glass. To adjust sensitivity, simply press
either the “Min” or “Max” button on the side of
the Wave To Play. Note: The sensor is on the
bottom of the case where the mounting holes
are located.
Connections, File To Play, Power & Trigger
• Either I/O jack can be used for Videotel Media
Players, RS232, TTL or dry contact trigger
• When the Wave To Play is connected the
“Power” LED will illuminate green
• When the Wave To Play senses a hand in close
proximity the “Trigger” LED will illuminate blue
TO
For additional instructions, videos and
help with connecting the Wave To Play
to our networked players or to a 3rd
party player, please scan QR code
Connecting Dry Contact Switch Terminal
The Wave To Play can be used as a dry contact
switch. When the Wave To Play is triggered an
internal relay is switched from the normally open
position (N.O.) to normally closed (N.C.) for 1
second. Simply connect the 6 pin I/O cable with
the orange 4 conductor terminal block (shown
below) into the Wave To Play. The terminal block
is labeled and requires 5VDC on the outside
connections. The 2 inside connections are the
switch.
Ground
Switch
Switch
+5VDC