Videx Kristallo Series User manual

66225045-EN - V1.1 - 30/06/16
1
Kristallo Series
Art.KRV983 - Installation instructions
Art.KRV983
Plaster board wall ush mounting kit for Kristallo Series hands free 3.5" video monitors
112 105
182
175
53
5÷16mm
WALL
OPENING
SIZE
CUSTOMER SUPPORTMANUFACTURER
All Countries:
VIDEX ELECTRONICS S.P.A.
www.videx.it - [email protected]
Tel: [phone] - Fax: [phone]
VIDEX ELECTRONICS S.P.A.
Via del Lavoro, 1 - 63846 Monte Giberto (FM) Italy
Tel [phone] - Fax [phone]
www.videx.it - inf[email protected]
UK Customers:
VIDEX SECURITY LTD
www.videx-security.com
Tech Line: 0191 224 3174 - Fax: [phone]
The product is CE marked demonstrating its conformity and is for distribution
within all member states of the EU with no restrictions. This product follows
the provisions of the European Directives 2014/30/EU (EMC); 2014/35/EU
(LVD); 2011/65/EU (RoHS): CE marking 93/68/EEC.

66225045-EN - V1.1 - 30/06/16
2
Kristallo Series
Art.KRV983 - Installation instructions
Art.KRV983
Plaster board wall ush mounting kit for Kristallo Series hands free 3.5" video monitors
135cm
Fig. 1
Fig. 4
NO YES
Fig. 7
Fig. 2
Fig. 5
Fig. 8
A
B
B
Fig. 3
Fig. 6
• Make a hole1in the wall of 105mm width and 175mm height. Between the bottom of the hole and the nished oor, leave approx
135cm as shown in Fig. 1;
• Run the cables into the central opening of the box, embed it in the wall as shown in Fig. 2;
(Note: make sure the direction is the same as shown in Fig. 2);
• As shown in Fig. 3, using a Phillips screwdriver, extract the hooks Bby loosening the screws A. Insert the screwdriver into the
top screw then push in upper direction then make the same with the bottom screw but push in the lower direction;
• As shown in Fig. 4, x the box2: using a Phillips screwdriver screw the screws A(Fig. 3) until the screw is tight (DO NOT OVER
TIGHTEN)3the hook Bis in touch with the inside side of the wall (Fig. 5);
• As shown in Fig. 6, connect the wires using a at screw driver then setup the intercom as per provided connection diagram or
instruction sheet;
• As shown in Fig. 7, once the wires are connected, x the intercom to the ush mounting box using a Phillips screwdriver and the
two screws provided;
In order to avoid malfunctions, please do not over tighten the xing screws shown in Fig. 7.
• Once the intercom is xed to the ush mounting box, place the front plate against the intercom by inserting the hooks in the
corresponding openings and hook the plate by pushing it down as shown in Fig. 8;
• Test the system for correct operation.
1 We recommend making an accurate cutout for the hole: 105mm width, 175mm height.
2 Before xing the box, be sure that the hooks B(Fig. 3) are totally taken out from the box: this will allow the hooks to slide easily during the xing.
3 Do not over tighten the screws to avoid damages to the hole edges or to the box.