5. Operation Controls and Functions
Front Panel
NO. Name Function Description
1OLED screen
Display matrix switching status, input/output port, EDID,
Baud rate, IP Address.
2Power LED
The LED will illuminate in green when the product is connected
to the power supply and red when the product is on
3Input / Output
buttons
You need to press an output button first then ,press an
input button (1~8) to select the output port's corresponding
source.
4
MENU / ENTER
/ UP /DOWN
①EDID Check:
On the initial OLED display screen, press
“MENU” button to enter the Matrix switching state interface,
then press the “UP/DOWN” button to check the current
EDID information of each HDMI input port.
②EDID setting:
On the initial OLED display screen, press
“MENU” button to enter the EDID setting interface, press
The “UP/DOWN” button selects the required DID and press
the “ENTER” button. A prompt “copy to input:” will appear.
Then press “the UP/DOWN” button to select the input port
you need to set and press the “ENTER” button again to
confirm.
③Baud rate setting:
On the initial OLED display screen,
The
press “MENU” button to enter the Baud rate interface,
and
Press the “UP/DOWN” button to select the required Baud
rate, and press the “ENTER” button to confirm the setting.
④IP Address Check:
On the initial OLED display screen,
press the “MENU” button to enter the IP interface, then
press
“UP/DOWN” button to check the current IP address.
Pressing the “MENU” button again will return to the initial
5POWER button
Long press the POWER button for 3 seconds to enter the
standby mode, then short press it to wake up the device.
6IR Window
IR receiver window only receives the IR remote signal
from this product.
7LOCK button
Press the LOCK button to lock the front panel buttons
(Except the power button); Press it again to unlock.
