PSA-TB-IP
IP Paging Speaker
Adapter with Talk-Back
April 29, 2021
1.0 Out-of-Box
1. 1 Verify that you have received all of the parts listed
QUICK START GUIDE
VIKING
Electronics, Inc.
KSee Product Manual for complete installation and programming instructions.
1.3 Download and install the programming software
1. Go to www.vikingelectronics.com and enter PSA-TB-IP in the search box
2. Click PSA-TB-IP in the search results
3. Scroll down the page to Downloads, click IP Programming Software
4. Install the programming software by saving or opening the file and then clicking on
setup Viking IP Programming.exe
5. Follow the prompts on your screen to complete software installation
2.0 Power Source
• Make sure the port is not in trunk mode
• Make sure port is capable of 100mbps full-duplex
• If Spanning Tree Protocol (STP) is enabled, enable Portfast and BDPU Guard Globally
Select PoE Switch or PoE Injector that meets the following requirements:
1. IEEE 802.3af / 802.3at / 802.3bt compliant
2. Capable of providing at least 13 Watts (class 0 or class 3)
Note: CAT5e (or higher) cable recommended
3.0 Network Port Settings
1.2 Download the product manual
1. Go to www.vikingelectronics.com and
enter PSA-TB-IP in the search box
2. Click PSA-TB-IP in the search results
3. Click Product Manual to open and
download the PDF
- OR -
Scan the QR code to
open and download
the product manual
X 1 PSA-TB-IP IP Paging Adapter
with Talk-Back
X 2 Gel-Filled Butt Connectors
X 2 #8-18 X 1/4” Pan Head Phillips
Sheet Metal Screw
X 2 3 Wire Lever Connectors
