ViLO HOME Tribeca VH1322 User manual

C1
C2
C2
C3
C4
C5
C6
C7
C7
C9
C8
Open Lock
Open
Lock
Open
Lock
Open
Lock
Open
Lock
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts that may have come
loose inside the carton during shipment. Please read all instruction carefully before assembling. For your safety, assembly by two
people is recommended.
ASSEMBLY INSTRUCTION
Tribeca 65" TV STAND
IMPORTANT SAFETY CONSTRUCION
PARTS INCLUDED: HARDWARE ENCLOSED:
·(C1) Top Panel x 1
·(C2) Side Panel x 2
·(C3) Front Frame x1
·(C4) Partition Panel x 1
·(C5) Left Bottom Panel x 1
·(C6) Right Bottom Panel x 1
·(C7) Shelf Panel x 2
·(C8) Support Leg x 1
·(C9) Back Frame Panel x 1
·A x 4 Knob
·B x 8 Bolt Ø4x25 (mm)
·C x 8 Shelf Pin
·D x 8 Wood Screw Ø3.5x15 (mm)
· x 1 Anti-Tip Kit
10 min Two People Required
Phillips Head
Not Provided
VH1322-VH1323-VH1324
Page 1 of 6

1 2 3
C8
EPE Foam
C4
C8
C4
Open
Lock
C3
Open
Lock Open
Lock
Open
Lock
ASSEMBLY INSTRUCTIONS
-Please lay all components on smooth flat surface to prevent scratches
-Use the EPE foam to protect the plastic hardware before assembly.
-Insert the Support Leg to the Partition Panel (See Detail A)
Detail A
Detail B
STEP 1:
STEP 2: - Make sure all latches are in the open position before installing
- Insert the Partition Panel (C4) to the Front Frame (C3). (See Detail B)
Page 2 of 6

1 2 3
C9
Open
Lock
Open Lock Open
Lock
Open Lock
C2
C2
Open
Lock
Open
Lock
Open
Lock
Open
Lock
Open
Lock
- Slightly insert the Side Panel (C2),(C3) and the Front Frame (C3),(C9). (See Detail D)
- Please match the corresponding numbers up to lock into place
STEP 3:
STEP 4:
Detail C
Detail D
- Slightly insert the Back Panel (C9) to the Partition Panel (C4). (See Detail C)
- Please match the corresponding numbers up to lock into place
Page 3 of 6
1 2 3

Open
Lock
C5
C
D
C6
C7
C7
Open
Lock
STEP 5: Insert the Bottom Panel (C5), (C6). (See Detail E)
Assembly the Shelf Panel (C7) with Shelf Pin (C) and Wood Screw (D). (See Detail F)
Detail F
Detail E
STEP 6:
Page 4 of 6

Open Lock
Open Lock
Make sure all 10 latches are in
the locked position
Open Lock
Open Lock
Open
Lock
Open
Lock
Open
Lock
Open
Lock
Open Lock
C1
Open Lock
- Make sure all latches are in the open position before installing.
- Carrying the top panel and slightly insert into the front - back and side panel
-Check all latches are in the locked position after the top panel in place
Detail G
Detail H
STEP 7:
Page 5 of 6

5
Adjustable Leveler Instructions
A
B
STEP 8:
STEP 9: Install the An-ti tipping kit to the wall for safety purposes. (See Detail J)
Assembly the Knob (A) to the Door (C3) with Bolt (B). (See Detail I)
Detail J
Page 6 of 6