Vinotemp VT-WINEDISP2 User manual

12

open cover
loose
tighten pull up
1. .
2. .
3. .
4. - .
5. ,
1,
.
6. .
:.
Press and hold the wine dispensing button to empyt the remaining gas
in the cartridge
Unplug the unit
Rotate the cover upwards to access the gas cartridge
Pull the cartridge and turn it counter clockwise to loose
Place a new cartridge and align it to the neck thread of regulator rotatge it
clockkwise only turn to position properly then turn clockwise all the way to
tighten
Move the cartridge back and close it
NOTE It is normal that a little gas escapes when the gas cartridge is being
tightened to the regulator

POWER
SWITCH
CONDERSER
PRESSURE
GAUGE

a Argon Nitrogen empty
b Bottle not tightened
c Defective bottle plug
d Gas tubing blockage
e Defective gas solenoid valve
f Defective wine solenoid valve
g Incorrect or loose wirings
./
.
.
.
.
.
.
a Check for cylinder pressue
b Check for bottle fixer and if gas escaping
c Check for bottle plug and if gas escaping
d Check for gas tubes
e Remove bottle press button to check if gas escaping
f Switch the problem valve to a good one
g Check all wirings and connections
.
.
.
.
.,
.
.
a Argon Nitrogen low
b Tubes kinked twisted
c Bottle neck leak
d Gas solenoid valve restricted
e Wine solenoid valve restricted
./
.,
.
.
.
a Check pressure and change a new cylinder
b Check for tubes
c Check for plug fixer
d Remove bottle press button to check if gas escaping
e Switch the problem valve to a good one
.
.
./
.,
.
Complaint Possible Causes Response