Vintage view FCF-2WB User manual

2. - Measure the
the calculated distance on both legs of the frame.
Measured Distance + 3/8” = Frame Height
3. Cut the frame
appropriate blade; squarely cut both legs of the frame at the marks from Step 2
Note
Wine Master Cellars, LLLP • 10645 E 47th Ave, Denver, CO 80239 • phone: [phone] • fax: [phone] • VintageView.com
Required tools: Phillips Head Driver / Drill Level
Metal Cutting Saw Pencil
Tape Measure Metal File
Included Parts: 2 Pieces FCF-2WB
For product warranty information, please visit: www.VintageView.com/support/warranty
We’re here to help, call us at 866-650-1500 with any questions.
There are pre-drilled mounting holes in each mounting plate. Appropriate fasteners for your surface must be utilized in every
mounting hole for proper installation. Hardware for attaching the brackets to the wall are not included. We recommend the
following fasteners for these surfaces:
Fasteners:
•Drywall installations should attach to joists or wood backing when available with a #8 X 1-1/2” course thread
screw or larger alternatively, use expanding hollow wall anchors with at least #8 screw size
•Wood surfaces use #8 X 1-1/4 course thread screws or larger
•Concrete, Brick or Stucco: 3/16” x 1 ¼” masonry screw or #8 x 1 ¼” screw with appropriate size expanding
concrete anchor
Note: If the calculated measurement aligns with one of the
frame and then mark the cut lines, measuring away from
the cut end of the frame.
1. Assemble the frame
Figure A
Figure B
Figure C
4. - Secure the WS-Series racks and/or FCF-BACK to the the
front and back faces (Figure E), ensuring that the coupled joint of the frame is
spanned by the back strip of a WS-Series rack or an FCF-BACK and that the rack
of the frame (Figure F).
Coupled Joint
FCF-BACK
Lower Frame Section
Upper Frame Section
WS-Series Rack
Figure D
Figure D
Figure E
Figure F
WINE CELLAR
INTERNATIONA L
Exclusive dealer of

For product warranty information, please visit: www.VintageView.com/support/warranty
We’re here to help, call us at 866-650-1500 with any questions.
Standard Base Plate
Hidden Base Plate
Wall Bracket
5.
horizontal plate. Then, install the wall brackets, and secure both sets with a self-
drilling screw through the side of the frame.
Standard Base Plate
Hidden Base Plate
Wall Bracket
6. Install the frame
to back and side to side using a level and fasten at the top through all available
Refer to the detail images below
Note
Hidden Base Plate, it may
be necessary to temporarily
remove the lower rack to easily
Figure G