Vintage view W Series Single User manual

W Series
Installation Instructions for W Series Single (WS-LEFT & WS-RIGHT)
• 1 “Single” Rack
• 2 Screws
• 2 Toggle Bolts
• 2 Mounting Hole Caps
• Phillips head screw driver
• Level
• Pencil
• Tape Measure
• Drill
Parts List Required Tools
Side Note:
Concrete, Brick or Stucco: 3/16” x 1 ¼” masonry screw or #8 x 1 ¼ inch screw with appropriate size
expanding concrete anchor - not included
Figure A
Figure B
1. Mark the mounting hole locations – (See
image below) to ensure appropriate minimum clearance
around the Single and hold the rack against the wall.
Use a level to ensure the rack is horizontal and mark the
mounting hole locations on the wall.
2a. Drill anchor holes for drywall – Drill
1/16 in pilot holes to determine if the holes are over
a stud. Drill ½ in (13.7mm) hole for the Toggle Bolts
centered on the marked hole locations.
2b. Install into wood – use a screw to fasten
the strip into the wood/stud at mounting point.

Instructions
Figure C
Maintenance and Care - Your W Series racks should be regularly inspected for secure wall attachment. Should
any fastener be found to be loose, tighten it appropriately. If the wall surface shows any signs of breakage,
discontinue use immediately until such time as the wall may be adequately repaired. W Series racks may be
cleaned with a damp cloth and mild dish soap – avoid vinegar, harsh chemicals such as bleach or degreasing
agents, abrasive cleaners, abrasive pads or steel wool.
3. Install the rack - Remove the expanding
nuts from the Toggle Bolts. Insert the bolts through
the mounting holes and, with the wings of the nut
oriented to fold toward the head of the bolt, thread
an expanding nut back onto each bolt until the tip
of the bolt starts to protrude from the end of the
nut. Hold the strip so the Toggle Bolt aligns with
the ½ inch holes and gently push the expanding
nut through the wall. Ensure that the wings of the
expanding nuts have fully expanded on the back
side of the wall and tighten the bolts, verifying that
the rack remains level.
Figure D Figure E
4. Install mounting hole caps in the ½ in holes on the face of the rack by pressing into place.
5. Add Wine Only the good stuff.