Vipclub CY-105-F-BK User manual

INSTRUCTION MANUAL
CustomerSer[email protected]
8883533768
Model: CY-105-F-BK

Package List
Without further ado, we kindly suggest you to list all parts needed
for the chair first.
(A)*1
Back
(B)*1
Seat
(C)
1 Base & 5 Legs
(D)*1
Gas Lift
(E)*5
Casters
(F)*2
Armrests
(G)*10
Yellow Bolts
(H)*1
Mechanism
(I)*4
Red Bolts
(J)*4
Blue Bolts
(K)*4
Bolts
(L)*4
Bolts Washer
(M)*1
Foot Ring
(N)*1
Wrench
2
8883533768
[email protected]
BLUE

Assembly Instruction
Step 1:
Step 2:
Insert the Gas Lift (D) to the
Base (C). Remove the cover
from the top of the Gas Lift.
Insert the Foot Ring (M) into
the Gas Lift (D) and fix the Foot
Ring (M) on the Gas Lift by rotating
the screw knob.
Note: Please match convex to
concave or it can't be installed
correctly.
1
2
Turn the Base (C) upside down, then
insert Legs (C) one by one to Base.
Use the Wrench (N) to screw 10 Yellow
Bolts (G) into the pre-drilled screw
holes to fix the Base and the Legs.
Press the 5 Casters (E) into the holes at
the end of each Leg.
3
8883533768
[email protected]

3
4
5
Step 4:
Step 3:
Turn the Seat (B) upside down and
align the hole position of the Armrest
(F) with the pre-drilled hole position
under the Seat.
Attach the Armrest (F) to the Seat
(B) with 2 Blue Bolts (J), using the
Wrench (N).
Repeat on the other side of Armrest.
The Bolt only needs to be screwed in
50%, which is convenient to install
the back cushion.
4
Attach the Back (A) to the Armrest
(F). Use the Wrench (N) to screw
4 Red Bolts (I) on the left and right
sides of the armrest to fix the back.
All Bolts (J) & (I) need
to be screwed in 100% now.
8883533768
[email protected]

Insert the slot on the back of
the Mechanism (H) behind
the cushion into the Gas Lift
(D).
5
6
6
Step 5:
Step 6:
Align the Mechanism (H) over the
pre-drilled holes underneath the Seat
(B), make sure the front of the Mecha-
nism (H) is facing the front of the seat.
Insert the Bolt Washer (L) into the
Bolts (K), attach the Mechanism (H)
to the seat with 4 Bolts (K), and
tighten all bolts with the Wrench(N).
*Be cautious as mis-threading
the bolts will damage the seat.
5
8883533768
[email protected]

6
Instructions For Use
1. Seat Height: Paddle-shaped lever on the right side
To lower:
While seated, lift lever up.
To raise:
While taking your weight off chair,
lift lever up.
Notice:
The role of the foot ring is only for
resting your feet when you sit down,
it can't be used to step on then climb
up the chair. It can't bear your weight.
2. Armrests adjustment 3.Adjustable lumbar support
The armrest can be adjusted.
Make it up and down if you need
The lumbar support can be adjusted.
Make it up and down if you need.
6
8883533768
[email protected]

Safety And Maintenance
Safety Information
9
Do not stand on the chair, Do Not use the chair as a stepladder.
Use this product for seating one person at a time.
Do not use the chair unless all bolts and screws are firmly secured.
Avoid contact with sharp objects to prevent puncturing the fabric.
Every 6 months, check all bolts and screws to ensure they are tight.
To clean, spot clean only using a damp towel and mild cleaner, first
test on a small, unseen area of fabric.
Chair weight limit not to exceed 250 lbs.
Sit in the center of the
chair, with your back to
the backrest
Do not push the chair
around when a person
is sitting in it
Do not push down on
the backrest when a
person is reclined
Do not place all your
weight on only the
backrest
Do not sit at the front
edge of the chair Do not stand on the chair Do not use the chair with more than one
person
7
8883533768
[email protected]

Limited Warranty
10
The producer promises to repair or replace any chair that is found to be
defective in material or workmanship within one(1) and year from the date
of original purchase so long as you, the original purchaser, still owns it.
This is your sole and exclusive remedy. This warranty is subject to the
provisions below.
This warranty does not apply and no other warranty applies to:
Normal wear and tear, which are to be expected over the course of
ownership.
Misuse, abuse, or excessive use of the product.
Modifications or attachments to the product that are not approved
by the manufacturer.
Products that were not installed, used or maintained in accordance
with product instructions and warnings.
Products used for rental or commercial purposes.
Damage caused by the carrier in-transit is handled under separate terms.
Normal use for seating is identified as the equivalent of a single shift,
forty- (40) hour workweek. To the extent that a seating product is used
in a manner exceeding this, the applicable warranty period will be
reduced in a pro-rata manner.
Some retailers might have custom models imported directly from the
factory and therefore are not supported by our local service team
because we don’t have the correct parts, please contact your retailer
directly for support. If you have any questions about that we will be
happy to assist and identify those items.
EXCLUSIONS:
SEATING USAGE:
8
8883533768
[email protected]

We adopt a 30 days return policy which means that all products purchased
on this website may be returned to us within the timeframe. You need to
contact us within 30 days after the product(s) came into your possession
and the product(s) must be returned to us without any undue delays.
Returned products must be returned in the same condition as they were
sent and they must be sent in its original packaging.
If the product is not faulty, (i.e. if you changed your mind or if you are
unhappy with the product for some other reason), the cost of shipping
will all on you. And it is your responsibility that the package arrives safely
to us so we recommend that you use a courier service where it is possible
to track the shipment.
If the product is faulty when you receive it please contact us and we will
help you out (see more information under Manufacturer Warranty).
We reserve the right to give a partial refund in cases when the product(s)
is not in an unused condition, is damaged or has missing parts not due
to our error.
Contact us through the contact form on our website and attach the invoice
to the message as proof of purchase. And please also write the reason for
the return.
We will then get back to you as soon as possible with information on where
to send the product(s).
As soon as we have received the product(s) and made an inspection we will
inform you of our decision.
If a refund is approved we will automatically credit the purchase to your
credit card or original method of payment.
If the product(s) is damaged, not in its original condition or missing parts
we will inform you if you are eligible for a partial refund. This is decided
from case to case depending on the severity of the damages or what parts
are missing.
RETURN POLICY：
HOW RETURNS WORK：
9
8883533768
[email protected]

CustomerSer[email protected]
8883533768