VISIONARY DESIGNS MOD-9001 User manual

© 2020
Order #XXXXX
Locked layer contains
placeholder marks.
Completed Assembly
Steps:
1) Attach base plate to bottom of post, using bolt.
2) Connect Z-plate to front of post, using bolts. See V4 Connector detail.
3) Attach Z-plate to top of post, using bolt.
4) Attach graphic to clamps. See Graphic Attachment detail.
Bolt
V4
Base
Plate
Bolt
Bolt
Bolt
Z-Plate
Post
V4
V4 Connector
Slide V4 into groove of post,
then secure with set screw.
Set
Screw
To prevent product loss, keep
all screws attached to V4 after
disassembling.
Keep V4 connectors attached to post when packing.
Post
V4
Knob
Set Screw
Connector
Clamp
1) Slide connector of clamp
into groove of extrusion.
2) Tighten set screw on
clamp, to secure in place.
3) Insert graphic into clamp.
4) Tighten knob on clamp,
to secure graphic in place.
Graphic Attachment
Clamp
Graphic
Clamp
Clamp
MOD-9001 Hand Sanitizer Stand w/ Graphic
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2020
Order #XXXXX
DO NOT USE POWER TOOLS
DO NOT USE SCREWS
THAT ARE STRIPPED
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
Hex Tool - Essential for Assembly
General Information