VISIONARY DESIGNS MOD-1377 Manual

© 2021
Order #XXXXX
Locked layer contains
placeholder marks.
Completed Assembly
Post
Mount
Plate
Clamshell
Set
Screw
Base
Bolt
Cord Management for iPad
Attach iPad cord to supplied USB extension
cord. Feed USB cord through top hole of
post, then out bottom hole of post.
Connect to power.
Cord
Access
iPad
Lock Lock
Clamshell
Steps:
1) Attach base to post, using bolt.
2) Attach mount plate to post, using set screw.
NOTE: Mount plate must rotate left and right,
before installing clamshell.
3) Attach clamshell to mount plate, using acorn nuts.
4) Insert iPad into clamshell, then route cords through
holes in post. See Cord Management detail.
5) Attach Z-Plate to post, using bolts.
6) Attach Literature Pockets to back of post.
Foam Lining
Removed
Home Button Shield
Optional Cover for Home Button
1) Remove foam lining from inside bottom of
clamshell.
2) Attach Home Button Shield with double-sided
tape to inside of clamshell, keeping top of
shield flush with clamshell opening.
NOTE: This is a permanent fix and can’t be
easily removed.
Acorn
Nuts
Clamshell
Literature
Pockets
Bolt
Bolt
Z-Plate
Rotate clamshell
to turn iPad from portrait
to landscape orientation.
MOD-1377 Sanitizer / iPad Stand
REV 9/2021
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2021
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information