
Phone
How to use the UVC GoWand™
Voltage 5V DC
Wavelength 270nm
Light Source 5 x UVC LED
Lifetime 1 Million+ Cycles
Working Temp -20ºC~40ºC
Specifications
Do not attempt to
look at UV LEDs
while unit is on.
UV light can be
irritating to the
eyes and skin.
Warning
1. Remove the device from its case.
4. UVC light will sanitize where it is directly in contact
with a surface. Edges and shadow areas should be
sanitized by moving the light over those areas for
an additional 15 seconds after the initial 15 seconds
is complete. Press the power button to start
supplemental 15 second sanitizing cycles.
2. Insert type C or lightning connector of device into
your phone. Your device must be unlocked so that
the GoWand™ can receive power.
3. Hold the phone and GoWand™ less than 2/3 inch
from surface and press the power button to turn on
the UVC light. The blue LED indicator will flash for 15
seconds. After 15 seconds the device will shut o. The quartz glass is fragile. Please handle with care.
*When used as instructed and based on 3rd party testing on Staphylococcus aureus
(Staph), Escherichia coli (E. Coli), and SARS-CoV-2 (COVID-19). Real world results may
vary depending on disinfection distance and surface material. Direct exposure to UVC
light is required to kill viruses and bacteria. Surface areas not directly exposed may not
be fully disinfected.
A full 15 seconds or greater is required to eliminate
up to 99.9% of Viruses and Bacteria.*
Shorter exposure time is not guaranteed to
inactivate any Viruses and Bacteria.
Please visit vitalight.com for the latest testing data and for more information.
ATTENTION: UVC light cannot be seen.
The blue light emitted is for a reference to guide
where the eective area is being sanitized.