Vitek VTD-MD5CH User manual

black
VITEK
VTD-MD5CH
Vandal Resistant Mini Dome
Camera
FEATURES:
• 1/3” Sony Super Had CCD
• 550 TV Lines of Resolution
• 3.6mm Fixed Lens Included
• Minimum Illumination of 0.3 Lux
• Can be Semi-Flush or Surface Mounted
• IP-66 Rated Vandal Resistant Aluminum Enclosure with
Polished Chrome Finish
• 12VDC Operation

1
INSTALLATION
B
C
D
F
G
H E
I
J
A
1) Align the camera unit with the
surface of the ceiling, make marks
on the ceiling in the places where
the screw holes are to be drilled,
and then drill the three holes.
2) Cut a hole (diameter:50mm) in the
ceiling for routing the cables.
3) Pass the power cable (H) and
video cable (I) from the camera unit
through the cable hole in the ceiling.
4) Align the three screw holes in the
camera unit (G) with the screw holes
in the ceiling, and then secure the
camera in place by tightening the
three tapping screws(J).
5) Use the supplied the four screws(F)
to secure the middle base(F) to the
bottom base(G)
6) Tighten the guide ring(C), then
adjustment the camera(D).
7) Attach the bubble(B) to the middle
base(E).
8) Attach the top cover(A) to the middle
base(E).
9) Use the supplied star-shaded L-
wrench to tighten the set screw on
the top cover.
Open Close

black
2
SPECIFICATIONS
VTD-MD5CH
Image Sensor
Sync System
Scanning system
Lens
Horizontal Resolution
Min. Illumination
S/N Ratio
Video Output
Effective Pixels
Electronic Shutter
CCD Features
Operating Temperature
Operating Humidity
Power Supply
Dimensions (Dia. x H)
Weight
1/3” Super HAD CCD
Internal
2:1 Interlace
3.6mm Fixed Iris Lens Included
550 TV Lines
0.3Lux
More than 52dB AGC OFF at 50IRE
1.0Vp-p composite, 75 Ohms
250k (275k Total)
1/60 ~ 1/100,000
AGC, ESC, BLC
14F ~ 122F (-10C ~ +50C)
Within 85% RH
12VDC (300mA Max Consumption) ** CENTER POSITIVE **
3.15” x 1.69”/2.47” (80mm x 42.8mm/62.8mm)
14.11 Oz. (400g)

28492 Constellation Road ValenCia, Ca 91355
WWW.ViteKCCtV.CoM
LIMITED LIABILITY WARRANTY
Your new Camera is guaranteed to be free from defects in materials
and workmanship for a period of three years from the date of
purchase.
The product must have been used only for its intended purpose,
and not been subjected to damage by misuse, willful or accidental
damage, caused by excessive voltage or lightning.
The product must not have been tampered with in any way then the
guarantee will be considered null and void.
This guarantee does not affect your statutory rights.
Contact VITEK directly for all servicing.