Vivo DESK-SKIRT-60 User manual

Black 60" Cable Management Desk Organizer
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
Instruction Manual
https://vivo-us.com/products/desk-skirt-60
SKU: DESK-SKIRT-60
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
Phillips
Screwdriver
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
PACKAGE CONTENTS
TOOLS NEEDED
ASSEMBLY STEPS
STEP 1
WARNING!
B (x2)
Side Bar
STEP 2
D (x3)
3/4” Screw
E (x3)
Mounting Clip
F (x6)
Upper/Lower
Bar
H (x4)
Joiner
A (x1)
Panel
Connect the centers of the T joiners (C) to the
ends of the middle bars (G). Connect the upper/
lower bars (F) to the sides of the T joiners, then
connect the joiners (H) and side bars (B) to the
sides to complete the frame assembly.
Drill Pencil
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
C (x4)
T Joiner
G (x2)
Middle
Bar
Open the flap and straps of the panel (A) and insert the
frame, making sure the frame is fully inserted and the
material is tightly stretched around it.

3
STEP 3
Place the plastic mounting clips (E) in the center
of each exposed portion of the steel bars.
STEP 4
Fasten the straps to secure the frame.
Center the assembled panel under the desktop.
STEP 5
NOTE: Make sure the
wire management
flap on the panel (A)
is facing the inside of
the desktop.
STEP 6
Mark the locations of the mounting clips (E) using a pencil. Drill pilot holes using a 1/8” (3mm) bit and
mount the assembled panel to the underside of the desk using the 7/8” screws (D) as shown.
STEP 7
Route and organize the cables and secure them using the flap on the panel (A).
NOTE: Desktop must
be at least 1” thick to
prevent screws from
poking out through
the top and damaging
the surface.

LAST UPDATED: 03/04/2020
Open Monday - Friday 7:00am - 7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times. If any
parts are received damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
[email protected] AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
AVG. RESOLUTION TIME (within oice hrs): < 15 M
www.vivo-us.com
Chat live with an agent!
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
309-278-5303