Vivotek AM-21M User manual

IP Surveillance
Installation Guide
VIVOTEK Fixed Dome Series
Wall-mount Bracket
Using AM-21M wall-mount bracket
and compatible accessories
Rev. 1.0
Corresponding part number:
AM-21M: 100217600G AM-21M_V01

2
Compatible VIVOTEK Cameras
I
Compatible Models Screw
A: IT9360-H, IT9380-H; M4x8
B: IT9389-H, IT9389-HT M3x8
You may also refer to VIVOTEK's website for the list of supported models. Support for other models can
be available through time.
Installation
II
Below are the locations of mounting holes.
Mounting Hole Denitions
Revision History:
* Rev. 1.0: Initial Release
NOTE:
1. It is presumed that this wall-mount bracket is installed with a hole drilled on the wall for
routing power wires, DI/DO, and Ethernet cables.
2. Route cables before you secure the wall-mount bracket to a wall.
3. For details on the cable connections with each camera, please refer to their Quick
Installation Guide.

3
English
Refer to the table below for the description of the included screws:
Screw Description Quantity Applies to
TP4x25 Phillips truss
head
4 Securing the
bracket to wall
Plastic anchors 4 Securing the
bracket to wall
M4x8 pan head 4 Securing camera
to bracket, A holes
M3x8 pan head 3 Securing camera
to bracket, B holes
For cabling and conguration details with each network camera, please refer to their
documentation.
Wall Mount Installation
Below is a general, sample procedure using a wall mount bracket:
1. Locate the position where you want to install the wall mount bracket and camera. Drill
holes on the wall for securing the bracket and for routing the cables.
2. Secure the bracket by hammering anchors into the wall and then fasten screws through
the four mounting holes on the bracket.
9.4

4
3. Route an Ethernet cable through the wall and the bracket. Install the waterproof
components around the Ethernet cable.
4. Turn the camera towards the eld of view of your interest. When done, align the
camera's screw slots with the corresponding mounting holes.
5. Secure the camera to the wall mount.
6. Follow the instructions on the camera QIG for the rest of the installation procedure.