Vixen Horns VXS9200B User manual

VXS9200B
INSTALLATION GUIDE
PAGE 1 of 3
BEFORE BEGINNING YOUR INSTALLATION
Read through the whole instruction guide before getting started with the installation. Professional installation is
recommended for this product.
CONTENTS
8-Sound Dual Snail Horn (Black)
8-switch Wired Control Box
Power Box
Mounting Hardware
SAFETY INSTRUCTIONS
Avoid dismantling this horn’s electrical elements.
Avoid setting up any parts of the horn where there is a risk of falling off or risk of coming in contact with water.
Avoid reaching out to touch or pick up any fallen or water submerged parts.
Set the horn up for use only in areas with adequate ventilation.
Avoid sounding the air horn when in close range to your ear(s) or the ear(s) of others.
Make sure your battery ground is detached before getting your installation started.
Employ equipment for eye protection during drill operations.
The specific voltage requirement for this horn is 12 volt DC, therefore installation must be done to a DC power
source of 12 volts.

VXS9200B
INSTALLATION GUIDE
PAGE 2 of 3
MOUNTING
HORNS
Identify a suitable area for mounting, preferably an unobstructed sheet-metal surface like the frame or body of
the vehicle so as to provide a firm platform which will help protect the horn from damage due to excessive
shaking. Do not attach the horn to any plastic or other flexible material.
Use the provided mounting hardware to attach both horns to the main bracket.
Using the main bracket as a guide estimate and mark the positions for the two holes and then perforate to
size using a drill.
Use the provided mounting hardware to attach the bracket to the vehicle.
CONTROL BOX
Find a mounting location for the control box in which you will have access to the buttons.
Mount the unit on the location chosen using the double-sided tape.
IMPORTANT: If the control box is going to be installed on a handle bar, use the included handle bar bracket
and four small screws.
POWER BOX
The length of the wire that connects the power box with the control box is 3 Feet (36 inches), find a suitable
mounting location for the power box that is within that length from the control box’s mounting location.
Mount the unit on the location chosen using two provided screws.

VXS9200B
INSTALLATION GUIDE
PAGE 3 of 3
ELECTRICAL CONNECTIONS
Each horn has two BLACK wires, one attached to one of the screws in the bracket (-) and one attached to the
housing (+).
On the Power Box:
HORN 1: Connect the RED (+) wire to the wire that is attach to the housing then connect the WHITE (-) wire
to the wire that is attached to the screw in the bracket.
HORN 2: Connect the RED (+) wire to the wire that is attach to the housing then connect the BLUE (-) wire to
the wire that is attached to the screw in the bracket.
On the opposite side of the Power Box connect the RED (+) wire to the positive (+) terminal of the battery or
alternator. WARNING: We highly recommend that you use a 20A fuse (not provided) to assure that the circuit
remains safe and will not be damaged by excess current.
Connect the BLACK (-) wire to ground, this can be an unpainted metal on the chassis of your vehicle.
OPERATION
To start using the dual snail horn set the vehicle's ignition to the ON position.
The 8 buttons in the control box are momentary switches, each one will produce a different sound while is
pressed. Available sounds: FAST / TOGGLE / MI / RE / DO / ALL-ON / TURN BACK / TELOLET
To stop sound’s playback release the button.