VMP LCD-2 User manual

For more information, please contact us at:
325 Log Canoe Circle, Stevensville, Maryland 21666
(T) 410.643.6390 / (F) 410.643.6615
www.videomount.com
VIDEO MOUNT PRODUCTS
Instruction Sheet For:
LCD-2 & LCD-2B

Step1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before at-
tempting to assemble the mount.
Through bolting the LCD-2
Step 2
Mark the desk or desired mounting surface in preparation of installa-
tion of the mounting bracket . Drill a ½” hole through the desired
mounting surface. Place a plastic washer on either side of the
drilled hole and place metal washers on top of the plastic washers
. Insert the M10 screw through the bottom most metal washer
through to the top most metal washer. Place the mounting bracket
onto the M10 screw and use nylon nut and washer to
secure in place. Warning: Please verify that your mounting surface will
support the combined weight of your mount, mounting hardware, and
monitor. Also verify that the mounting surface is safe to drill through. If
in doubt, please contact a professional installer.
Proceed to step 5.
Clamping the LCD-2
Step 3
Make sure the flat head screw is connecting the mounting
bracket to the base seat with a plastic washer in be-
tween. Use the nylon nut and washer to secure the mount-
ing bracket . Note: The mount may come assembled with the
button cap M10 screw attaching the base seat please make
sure to attach the flat head screw instead.
Step 4
Place the clamp on the edge of the desk or mounting surface and
turn the adjustable bolt until the fixed plate on the adjustable
bolt is tight against the bottom of the desk or desired mounting
surface. Warning: Please verify that your mounting surface will sup-
port the combined weight of your mount, mounting hardware, and
monitor. If in doubt, please contact a professional installer.
Step 2: Through bolting the mount
bracket
Step 3: Connecting the base seat
to the mounting bracket
Step 4: Clamping the mounting
bracket to the desk
VIDEO MOUNT PRODUCTS
1
11
7
9
78
9
10
1
5
1
7
2
111 10
8
3
3

Step 5
Determine if whether your monitor has a VESA 100 or VESA 75 hole
pattern. If the monitor has a VESA 75 hole pattern skip this step. At-
tach the VESA 100 plate to the back of your monitor using the M4 or
M5 screws or as appropriate for your monitor.
Step 6
Attach either the VESA 100 plate or your monitor to the VESA 75
holes using the 6mm long M4 screws if you are attaching the VESA
100 plate or the 12mm long M4 or M5 screws or if you are
attaching the monitor directly.
Step 7
Please verify that all nuts and screws are tight.
Step 5: Attaching the VESA 100
plate to the monitor
Step 6: Attaching the VESA
100 plate or monitor to the
mounting bracket
WARNING: The installer of these products must verify that the mount-
ing surface, ceiling or wall, will safely support the combined weight
of all attached equipment and hardware. Video Mount roducts will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
13
12
13
12