vMyst vTube User manual

QUICK START
On the top of the warmer insert a vTube open side down.!
!Press and hold the power button for 3 seconds. After about 10 seconds the warmer will
vibrate letting you know it’s ready - you can then take a drag as normal.
Using vMyst is very similar!to traditional smoking. Drag and use as you would normally.!There is no
need to keep!the button pressed while using, it will stay active for about 4 minutes, about the
same time as it takes to smoke a traditional cigarette. If you drag slower than average, or want to
take a break, the warmer!will automatically turn off. You can continue using a vTube until it is fully
consumed - all at once or over time. The unit will vibrate and blink when it’s about to turn off. You
can still take 1-2 drags after the cycle ends - simply repeat this process as desired.
If there is any damage to the unit, please do not continue to use and contact us as soon as
possible. Please see the FAQ on our site for more detailed information. Please contact us anytime
on our website by clicking the chat button on the bottom of any page.
INSTRUCTIONS
vMYST
1
2

Indicator Lights The side led light lets you know how much battery power you have. Green = 75%
+ Blue = 25%-75% Red = less than 25%.
Charging the fastest charging method (26 minutes from 0% to 100%) is to use the usb charger,
plugged into a wall adapter. To use the magnetic charger, plug the micro magnet connector into
the port on the bottom of the warmer. Then plug the cord in & magnet-connect to the micro plug.
Magnetic charging is very convenient but it is about 1/4 the speed of plugging into the wall so if
you want a full charge fast, use the standard USB plug into a wall charger. The red light will blink
when low power. You can have the unit plugged in while in use if convenient.
Self Cleaning & Cleaning press the button 5 times consistently and the
warmer will enter self cleaning mode. The red light will flash 18
seconds while cleaning. Please do not use or press the button during
this time. Every 5 vTubes or so, you can turn the unit upside-down
and gently tap to remove any small debris. You can also use the
cleaning tools supplied to clean the heating element. Please do this
very gently, to prevent any damage to the delicate coil. Please do
not disassemble the unit - there is no need to do this to clean.
Follow all battery disposal methods when it’s time to discard.
vMyst.com