Volt Polska VP200 User manual

PRODUKT MANUAL
230-110V
(500-5000V)
VOLT POLSKA Sp. z o.o.
ul. Grunwaldzka 76
81-771 Sopot
www.voltpolska.pl
[email protected] (58) 341-05-06 | [email protected] (58) 341-38-80 | [email protected] (22) 100-42-99
Voltage Converter
VP
Caution
Avoid overloading
Do not use the converter beyond its maximum power. When connected to any
appliance with built-in motor compressor, the starting power is generally
several times of the appliance's listed power rating. Make sure that the total
starting power capacity of all connected appliances does not exceed the listed
maximum output power of the converter. For color TV, calculate it twice as its
listed capacity. Make sure that the converter is of the same output voltage and
frequency as the appliances' it connected.Make sure that the voltage of electri-
cal source is the same as the input voltage of the converter.
Always place the converter in an environment that is:
- Well ventilated.
- Not exposed to direct sunlight or heat sources.
- Out of reach of children.
- Away from water moisture oil or grease.
- Away from any flammable substance.
If the power cord is damaged, it must be replaced by the authorized dealers or
similarly qualified persons in order to avoid a hazard.
Remarks:
This model is single phase.
Waveform is sinuousand without distortion.
Warning: Incorrect selection of input voltage may cause
permanent damage to your converter and equipments.
CAUTION
[email protected] (58) 341-05-06 | [email protected] (58) 341-38-80 | [email protected] (22) 100-42-99

Circuit Breaker
Air Switch
Output Voltmeter
Instruction to the converter
Familiarize yourself with the various features and facilities by studying the two
diagrams below to obtain maximum benefit from the converter.
Front of the converter
Rear of the converter
Connect the electrical appliances to converter
Check the wattage requirement of your equipment from the name plate and specs to
determine the correct wattage and which converter to be used. If your appliances
voltage rating is 110V/120V, your main voltage must be 220V/240V, then connect
appliance to 110V. If your appliances voltage rating is 220V/240V, your main voltage
rating must be 110V/120V, then connect appliance to 220V.
Connect converter to electrical mains
Plug the AC mains cord to wall mains socket as shown in diagram below and
switch "ON”. If mains power is 220V/230V/240V, please connect the main socket
or wall terminal box to converter’s terminal 220V, like (1) showing. If mains power
is 110V/120V, please connect the main socket or main terminal box to
Switch on the converter
(1) Switch the power “ON”.
(2) Press the power “ON/OFF” switch to “ON” position and Voltmeter will
illuminate the output voltage.
(3) Switch “ON”the appliances one by one.
Make sure all appliances are turned “OFF”
Make connections as shown in diagram below ensuring that the total starting power
needed does not exceed rated maximum output power of the converter.
Select the correct input voltage according to your area mains.
220V
Circuit Breaker
V
~
NLGN
L
110V 220V
Step-Up & Step-Down Vo ltage Converter
Main
Socket
220V
Circu it Brea ke r
Ste p-Up & St ep-Do wn Volta ge Con verte r
(1) 220V
(2) 110V
110V 22 0V
Earthin g
Main
Terminal Box
LNG
converter’s terminal 110V, like (2) showing. No matter 110V or 220V input, must
need connect Earthing/G. When you finish the connect to electric power,
please do the (1) (2) of 4 instruction “switch on the converter” to check the
voltage displaying on voltmeter is the same as your appliance. If yes, then
turn off the converter and go to 3 instruction. If no, please do again
the 2 instruction till it is right.
Mult istar
Multi star
Television
Refrigerator
220V
Circuit B re aker
Ste p-Up & St ep-Do wn Volta ge Co nve rte r
NLGN
L
110V 220 V
Thank you for purchasing Voltage Converter VP 230-110V from VOLT POLSKA.
Please read this product user before starting the device.

[email protected] (58) 341-05-06 | [email protected] (58) 341-38-80 | [email protected] (22) 100-42-99

MODELS
VP200
VP500
VP1000
VP2000
VP3000
VP5000
NAP. WEJ.
230VAC
230 VAC lub 110 VAC
NAP. WYJ.
110 VAC
230 VAC lub 110 VAC
MOC
200 VA
500
VA
1000
VA
2000
VA
3000
VA
5000
VA
SOFT-START
NO
YES
INNE
1 x GWY
2 x
GWY
3 x
GWY
4 x GWY
TECHNICAL DATA
MODELS VP
VP 3000V
[email protected] (58) 341-05-06 | [email protected] (58) 341-38-80 | [email protected] (22) 100-42-99
FILL IN IF NEEDEED
(*) Cross incorrect
I agree to pay the cost of inverter repair due to:
* expiration of the warranty period / * warranty void
Before proceeding with the repair, service will inform by phone about the
exact costs of the repair.
Please attach a copy of the purchase document (receipt or invoice) to the
complaint.
The full regulations of service repairs can be found on our website
DATE OF PURCHASE
SHIPPING ADDRESS
SIGNATURE / STAMP
DAMAGE DESCRIPTION
SERVICE COMMENTS
WARRANTY CARD
VP 300V