Voltronic Power Alfa DIY-2-BAT User manual

Battery Bank
100Ah x 2 pieces
Suitable for 3KVA Inverter
Version: 1.0
Quick Guide

Package Contents:
(1 piece)
(1 piece)
Top Case
Bottom Case with wheel
(1 piece)
(1 piece)
Left side Case
Right side Case
(1 piece)
(1 piece)
Front door
Rear door
(1 piece)
(2 pieces)
Breaker fix Case
Battery fix bracket

(6 pieces)
(14 pieces)
(1 piece)
(1 piece)
(1 piece)
M3 screw
M4 screw
Cable #A
Cable #B
Cable #C
Overview:
- Max. dimension of each battery: 400mm x 173mm x 230mm
- For cascading battery banks, please order cable kit
2
1
2

Assembly Procedure
1. Assemble right side case into three holes on bottom case with 3
pieces of M4 screws. Apply the same installation procedure to
left side case. Refer to chart below.
2. Put two batteries inside of battery bank. Please make sure that
the battery should be assembled as recommended direction.
3. Fix two batteries on the bottom case with battery fix brackets by 4
pieces of M4 screws. Refer to chart below.
4. Fix front door between left and right cases with 2 hooks. Refer to
chart below.
3
4

5. Fix rear door between left and right cases. Refer to chart below.
6. Install breaker fix case on top of rear door with 2 pieces of M3
screws. Refer to chart below.
7. Assemble cables as below. Cable #A is used to connect two
batteries. Cable #B is used to connect to breaker and positive
polarity of one battery. Cable #C is used to connect to breaker
and negative polarity of the other battery.
8. Simply put top case on to the unit with 4 pieces of M3 screws.
Then, battery bank is assembled completely.
5
6