Volvo XC90 Excellence Owner's manual

XC90
E X C E L L E N C E
SUPPLEMENT

VÄLKOMMEN!
This supplement describes the rear seat functions in your Volvo XC90 Excellence. Additional owner's information is available in your vehicle,
in an app and on the Internet.
THE CENTER DISPLAY
The Owner's Manual is available in the center display in top view.
MOBILE APP
The Owner's Manual is available as an app (Volvo Manual) for smart-
phones and tablets. The app also contains instructional videos for certain
functions.
VOLVO'S SUPPORT SITE
Go to Volvo Cars' support site (support.volvocars.com) for manuals and
instructional videos. Additional assistance and information about your
vehicle and owning a Volvo is also available on the support site.
PRINTED INFORMATION
The glove compartment contains a printed supplement to the Owner’s
Manual containing information about fuses and specifications as well as a
summary of other important and practical information. A complete printed
version of the owner's information (or a new Owner's Manual supplement)
can be ordered.

CONTENT
01. REAR SEAT TUNNEL CONSOLE
This chapter describes the features of the tunnel console in the rear seat, such as the touchscreen control panel
and what can be controlled from it, as well as the cooler and information on how to heat and cool beverages.
02. SEAT SETTINGS
The following information describes how to adjust and set the seats and other seat functionality.
03. INTERIOR OVERVIEW
This section contains information about the vehicle's interior, including an overview of the various storage spaces.
04. SUPPLEMENTARY INFORMATION
Warning, caution and note texts, which must be read.
All options and accessories, known at the time of publication, are marked with an asterisk: *.

REAR SEAT CONTROL PANEL
From the touchscreen control panel, which is located in the tunnel con-
sole between the rear seats, you can control settings for seat functions
and beverage heating/cooling.
Folding up the screen
–Press the upper side of the screen. The screen will move up and
start automatically.
The screen will dim after a short period of time if it is not used. Touch
the screen to reactivate it.
Folding down the screen
The screen is folded down manually.
–Press the upper side of the screen. Press until the screen is fully
recessed in the tunnel console. The screen will switch off when it is
folded down.
01

NAVIGATING IN THE CONTROL PANEL
The control panel is a touchscreen that contains a number of different
views. Tap a button on the screen to activate or change settings for a
function.
Buttons in Home view
Left/right seat heating.
Cooling/heating of cup holders.
Left/right seat ventilation.
Adjustment of front passenger seat from the rear seat.
Returning to Home view from another view
The control panel automatically returns to Home view after a certain
period of time if it is not used. After adjusting the front passenger seat,
tap the X to return to Home view.
01

COOLER
A cooler with space for two bottles and the crystal glasses provided
with the vehicle is located behind the rear seat armrest.
Press the button above the cover to open the cooler.
There is a control for adjusting the temperature inside the cooler.
The cooling function is active when the engine is running or when the
vehicle is in ignition mode II.
BEVERAGE HEATING AND COOLING
There are two cup/glass holders in front of the armrest and a holder to
heat/cool a cup of coffee/bottle of water, etc.
–Press the cover to open the holder. The heating/cooling function is
controlled from the control panel. Blue LED lights indicate that cool-
ing is active, and red lights indicate that heating is active.
The heating/cooling function can be activated when the engine is run-
ning or the ignition is in mode II.
Tap the button in the control panel repeatedly to shift between
the cooling and heating functions. The button will display the
set mode.
01

FOLDING TABLES
Two folding tables are stowed in the center armrest between the rear
seats.
1. Open the armrest cover completely.
2. Use the leather tab to lift the table out of the armrest to the fully ver-
tical position.
3. Fold the table down over the seat and slide it to the side.
Repeat the above steps in the reverse order to stow the table.
01

USB PORTS AND ELECTRICAL SOCKETS
USB port: There are two USB ports under the rear seat armrest. The
ports can be used to e.g. charge a cellular phone or a tablet. There are
also two USB ports on the tablet holders* on the rear side of the front
seat head restraints. The ports can be used to e.g. charge a cellular
phone or a tablet.
The USB ports cannot be used to play media in the vehicle's audio sys-
tem.
Electrical sockets: There is a 12-volt electrical socket and a 120-volt
electrical socket under the rear seat armrest.
120-volt: The socket can be used for 120-volt devices such as charg-
ers, laptops, etc. (maximum power output 150 W).
–Plug in the device to connect it. Disconnect the device by pulling the
plug from the socket.
12-volt: The socket can be used for 12-volt devices such as MP3 play-
ers, cellular phones, etc. (maximum power output 120 W).
–Remove the cigarette lighter from the socket and plug in the device.
Unplug the device and replace the cigarette lighter when the socket
is not being used.
The ignition needs to be in at least mode I for the USB ports and elec-
trical sockets to provide electrical current.
01

ADJUSTING REAR SEATS
The vehicle's rear seats can be adjusted using the controls on the side
of the seats.
Change the tilt of the backrest by moving the control forward/rear-
ward.
Raise/lower the seat by adjusting the rear section of the control
upward/downward. Move the seat forward/rearward by moving the
control forward/rearward.
Raise/lower the front edge of the seat cushion by moving the front
section of the control up/down.
Settings for massage, side bolsters, lumbar support and seat cush-
ion extension are linked to the multifunction control.
Only one movement (forward/rearward/up/down) can be performed at
a time. The seat can be adjusted when the ignition is switched on and
for a certain period of time after the door has been unlocked even if the
ignition is not on. Adjustment is also possible for a certain period of
time after the ignition has been switched off.
The seats have an overload protector that is tripped if a seat is blocked
by any object. If this occurs, remove the object and attempt to adjust
the seat again.
To adjust sleep/comfort mode, it may be necessary to first move the
seat forward slightly.
02

ADJUSTING SEAT SETTINGS
To adjust lumbar support, side bolsters, seat length extension and mas-
sage settings, use the multifunction control on the side of the seat. Set-
tings made using the multifunction control are shown in the control
panel. The display only shows the settings for one seat at a time.
1. Fold up the control panel.
2. Activate seat adjustment by turning or pressing the multifunction
control in any direction. The seat setting view will open in the control
panel.
3. Select the desired function in the control panel by tapping the dis-
play or turning the multifunction control upward/downward.
4. Change setting by pressing the control in any direction.
Massage
Tap the button on the screen or select the function using the
multifunction control to activate the massage function. The
massage function cannot be used when the ignition is
switched off.
The following massage settings are available:
On/Off:
Select on or off to switch on/switch off the massage function.
Programs 1-5:
There are five preset massage programs. Choose between 1
(Swell), 2 (Tread), 3 (Advanced), 4 (Lumbar) and 5 (Shoulder).
Intensity:
Choose between low, normal and high.
Speed:
Choose between slow, normal and fast.
02