VonHaus 14/087 User manual

2000W
FREESTANDING
FIREPLACE
14/087 - Instruction Manual

CONTENTS
Safety Instructions 1
Safety Instructions, Safety Symbols 2
Specification 3
Installing the Fire 4
Operation, Cleaning & Care 5
Safety Features, Troubleshooting 6
Warranty 7

WARNING
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
INTENDED USE.
This 2000W Freestanding Fireplace
designed for light domestic use only. It is
not intended for heavy duty, commercial
or industrial use, and is not suitable for
use outdoors.
WARNING! Do not use this appliance to
dry clothes.
This appliance is not intended for
use by children or infirm persons
without supervision. Extreme caution is
necessary when used near children, and
whenever the appliance is left operating
unattended. Take adequate precautions
if such persons are to be left alone in the
vicinity of the appliance.
WARNING! This product is not suitable
to be used on long pile carpets.
Use this appliance only as described
in this manual. Any other use is not
recommended by the manufacturer and
may cause fire, electric shock or injury.
PRIOR TO USE.
Remove the packaging and make sure
that the appliance is intact. If in doubt, do
not use the appliance and contact DOMU
Brands Customer Services.
Do not leave packaging materials such as
bags and staples within reach of children.
Dispose of packaging carefully and with
consideration for the environment.
It is recommended that you retain the
appliance box for seasonal storage.
For your convenience, record the date
you received the appliance on the
‘Warranty’ page of these instructions and
attach your proof of purchase. Retain this
information in the event that a warranty
service is required.
SAFETY INFORMATION.
When using any electrically-powered
appliance, basic safety precautions should
always be followed to reduce the risk of
fire, electrical shock, or injury to persons
or property.
CABLES AND PLUGS.
Check to ensure your electricity supply
matches that shown on the rating label of
the appliance. The appliance must only
be used as rated.
Do not operate any appliance with a
damaged cord or plug, or after the
appliance malfunctions or has been
dropped or damaged in any manner. Take
to a qualified electrical person for service
and repair.
Do not connect the appliance to the
mains voltage until completely assembled
and adjusted.
Unroll the cord before operating.
Operating with a coiled cord may cause
overheating and risk of fire.
The use of an extension cord with this
appliance is not recommended.
Do not allow the cord to come into
contact with the appliance surface during
operation.
Do not run the cord under carpeting,
mats or rugs etc. Arrange the cord away
from traffic areas so that it will not be
tripped over.
Do not twist, kink or wrap the cord
around the appliance as this may cause
the insulation to weaken and split.
Always unplug the appliance when not in
use. Do not leave unattended.
Always switch off the appliance before
unplugging from the power socket.
Always hold the plug when removing it
from the wall, do not pull the cord.
CAUTION: In order to avoid a hazard due
to inadvertent resetting of the thermal
cut-out, this appliance must not be
supplied through an external switching
device, such as a timer, or connected to
a circuit that is regularly switched on and
off.

WARNING
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
2
RISK OF PERSONAL INJURY.
Use this appliance only as described in
this manual.
Do not use this appliance with any type of
external timer.
Always operate upright, on a flat surface
only.
This appliance heats up when in use. To
avoid burns, do not touch the front of the
appliance or any of the grilles or vents.
WARNING! DO NOT COVER.
Do not cover in any manner as the
appliance may overheat and become a
fire risk.
Keep all objects at least 1 metre from the
front, side and rear of the appliance.
Do not operate the appliance with wet
hands.
Do not immerse in liquid or use the
appliance near water as this could create
an electrical shock hazard.
If the appliance accidentally comes into
contact with water, switch off the power
supply and do not touch the appliance.
Never attempt to remove the cover of the
appliance. Repairs requiring opening the
appliance or access to internal parts must
be carried out by a qualified electrician or
repair service professional. There are no
user-serviceable parts of this appliance
(excluding the plug fuse).
Before moving the appliance, switch it
off by unplugging it from the wall and
allowing it to cool.
POSITIONING YOUR FIREPLACE.
This appliance is designed to be
placed on a hard, level surface. When
positioning, please keep the following
points in mind:
Do not locate in areas of high foot traffic.
To avoid accidents, always ensure that the
power cord and appliance are in full view.
Do not fit the appliance in confined
spaces such as cupboards or wardrobes.
Do not operate the appliance in areas
where gasoline, paint or other flammable
liquids are used or stored.
Do not operate the appliance in
bathrooms, laundry areas or similar
moist indoor locations. Do not use in
the immediate surroundings of a bath,
shower or swimming pool.
The appliance must not be located
immediately below or in front of a socket
outlet.
The socket must always be accessible in
order to disconnect the appliance from
the electrical supply for maintenance.
Store the Fireplace carefully in a dust-free
area during the off season.
It is ideal to store the Fireplace in the box
in which it was supplied.
Neatly wind the cord of the Fireplace to
prevent damage.
Please ensure you understand their meanings before operating this product in
order to prevent personal injury and avoid damage to the appliance.
WARNING!
Pay attention to all
safety and guidance
Read manual
before use
WARNING!
Do not cover
SAFETY SYMBOLS

SPECIFICATION
220-240V ~50Hz
V
VOLTAGE
1000/2000
W
HEAT
SETTINGS
4
1
2
5
3
1. Frame
2. Metal Housing
3. Fireplace Switch
4. Pebbles
5. On/Off Switch

4
INSTALLING THE FIRE-
FREESTANDING:
Locate the Fireplace in a suitable area ensure that it is
kept 1m clear of any combustible objects, plug into a
suitable outlet.
FULL INSET:
NOTE: Screws not supplied for inset fittings.
Remove the 4 screws located at the back of the
Fireplace to remove the metal frame and convert into
an inset Fireplace.
Mark the centre of the opening of the fireplace.
Measure 215.5mm to the left and then again to the
right. From this point measure from the floor 560mm
upwards. Once measured mark these positions on
the wall.
Drill the holes using a suitable sized drill and insert
suitable screws leaving 2mm of the screw visible.
Once both screws are in place lift the Fireplace onto
the screws and set down in place.
When installing the Fireplace ensure the correct
measurements are used for sufficient ventilation use
the table below as a guide.
Dimension Minimum Maximum
Width 400mm 483mm
Height 560mm 590mm
Depth 125mm 125mm
2mm
400mm
125mm
560mm

OPERATION
Before use arrange the supplied pebbles into a
desired layout.
NOTE: Do not move the Fireplace with the Pebbles
in place.
Insert the plug into mains socket.
TO POWER ON THE FIREPLACE:
Switch the On/Off Switch located on the left of the
Fireplace to the on position this will activate the
Flame Effect only.
FIREPLACE SWITCH:
LOW HEAT
FLAME EFFECT ONLY
HIGH HEAT
CLEANING & CARE
CAUTION: Switch off the Fireplace and disconnect
the plug from the power socket. Wait for the
Fireplace to cool completely before cleaning.
To remove dust on external surfaces, wipe the
Fireplace with a damp (not wet) lint-free cloth rinsed
in hot soapy water only.
CAUTION: Do not use any harsh detergent or
abrasive cleaners.
WARNING! Do not spray with any liquids or
submerge in liquid or water.
WARNING! Do not attempt to clean the inside of
the Fireplace. Do not attempt to open the Fireplace
casing at any time. There are no user-serviceable
parts.

6
TROUBLESHOOTING
PROBLEM SOLUTION
LIGHT BUT NO HEAT Check that the Heat Switch is switched to low/high
heat.
Fireplace Switch is Switched on.
Ensure the Fireplace is switched on and connected to
mains power.
Activate the On/Off Switch.
Check the fuse by replacement.
Check that the Fireplace is plugged in and switched
on at the mains outlet.
Make sure that the Fireplace has not gone into
overheat protection mode (see ‘Safety Features’).
The Vents may require need cleaning.
Discontinue use and contact DOMU Brands Customer
Services.
THE FIREPLACE WILL NOT POWER
ON
THE FIREPLACE IS NOT HEATING
THE FIREPLACE BECOMES
DAMAGED
SAFETY FEATURES
This Fireplace is fitted with an overheat protection
switch (thermal cut-out) which will power off the
appliance automatically in case of overheating.
Should this occur, unplug the appliance and allow to
cool fully for approximately 30 minutes.
NOTE: The Fireplace will not switch on again
automatically.
Follow the operation instructions to restart
the appliance after removing the source of the
overheating (poor ventilation, item covering the
Fireplace etc.). The Fireplace should function
normally. Should the problem persist, please contact
DOMU Brands Customer Services.

DISPOSAL INFORMATION
COPYRIGHT
WARRANTY
CUSTOMER SERVICE
Please recycle where facilities exist. Check with your local authority for recycling advice.
All material in this instruction manual are copyrighted
by DOMU Brands.
Any unauthorised use may violate worldwide
copyright, trademark, and other laws.
To register your product and find out if you qualify
for a free extended warranty please go to
www.Vonhaus.com/warranty.
Please retain a proof of purchase receipt or
statement as proof of the purchase date.
The warranty only applies if the product is used
solely in the manner indicated in the Warnings page
of this manual, and all other instructions have been
followed accurately. Any abuse of the product or
the manner in which it is used will invalidate the
warranty.
Returned goods will not be accepted unless re-
packaged in its original packaging and accompanied
by a relevant and completed returns form. This does
not affect your statutory rights.
No rights are given under this warranty to a
person acquiring the appliance second-hand or for
commercial or communal use.
If you are having difficulty using this product and require support, please contact [email protected]

VonHaus®is a registered trademark of DOMU Brands Ltd
Made in China for DOMU Brands Ltd BL2 2HH
Thank you for purchasing the 2000W Freestanding Fireplace.