
• For thick oil or on cold days, turn the PILOT on by
pressing the button FIVE times, then press the
button TWO times to start the pre-heat setting. This
setting heats the oil at a low temperature
and will loosen up thick oils.
• When the pre-heat cycle initiates the LED light
behind the button will cycle through all three colors.
• You can end the pre-heat cycle at any point by
holding the button down. The unit will then fire at
the current temperature setting.
OPERATION:
PRE-HEAT SETTING:
• To charge your battery attach the unit to the USB-C
charger included in your kit.
• The PILOT button will light up as it is charging.
• When the light is no longer on, the unit is fully
charged.
• The light will blink red three times and no vapor will
be produced when the unit needs charging.
CHARGING: TIPS & TRICKS:
WARNING:
INDICATOR LIGHTS:
CLEANING & CARE:
• LOW BATTERY - The light will blink three times in
red. This indicates the PILOT needs to be charged.
•Heating Element Issue - The LED light will flash 3
times in purple, pink, or white. Try turning the cart
back half a turn. If the problem persists contact
Vuber.
• The connection point on your PILOT battery can
accumulate oil residue over time.
• Clean off the PILOT and cartridge connection points
periodically with a cotton swab soaked in isopropyl
alcohol, as residue may have accumulated.
• Gently wipe the swab on the battery and connection
point.
• Do not leave the battery in excessive heat and cold
environments. This may degrade battery life.
• Not all oil is made the same - `a heat setting that
gives the best flavor profile for one brand may not
be the best choice for another.
• The viscosity (thickness) of oil will change with
changes in temperature. Try not to leave your
cartridge in your car on warm days and understand
that on cold days it might take some time priming
the battery (activating it with short suction bursts)
to get vapor production.
•Before removing cartridge, fire battery for 3
seconds to loosen up any oil residue that may have
leaked out of the cartridge bottom. If oil has leaked
it can cause damage to the connection points when
unscrewing your cartridge.
• If your battery is blinking pink, purple, or white try
Using modified or homemade atomizers can be
dangerous. Vuber is not responsible for damage
caused by improper use.
MUST BE 21 or OLDER TO USE THIS PRODUCT.
STEP 1 - Attach your favorite pre-filled cartridge.
STEP 2 - Click the button FIVE times to turn the
unit on/OFF
STEP 3 - Choose your preferred setting by pressing
the button three times to cycle through
voltages:
•GREEN - 2.8v - Less Vapor, More Flavor
•BLUE - 3.4v - More Vapor, Less Flavor
•RED - 3.8v - Best for Wax Atomizers
STEP 4 - Press the button, hold it down, and gently
inhale on the mouthpiece.
STEP 5 - Exhale and enjoy!