Back panel:
1. " " - x2 pcs for mounting brackets into a 1U 19" rack slot.1U 19 inch brackets
2. " " - Displays article number of the monitoring unit.Logo sticker
3. " " - A place for a sticker, can be used by a user to place an identifier of the system (for example, an IP Sticker space
address).
4. " .. " - 8 RJ12 analog sensor inputs with auto-sensing. Read instructions at " ",Analog sensors: A1 A8 Analog sensors connection
" ".Sensor configuration
5. " " - Ethernet 10/100 Base-T port, provides an Ethernet connection. Read more in this section "LAN port LAN, GSM, LTE,
".RADIUS, DNS, SSL, VPN
" " - orange LED for Ethernet port. It shows network traffic.Orange LED
" " - green LED for Ethernet port. It shows network traffic. Flashes green when the system starts up. Shows Green LED
the connection state (constant green light - the connection is established, blinking green - the connection attempt).
6. " " - " " can be installed in this slot. Modem slot VT790 / LTE slot modem
Read instructions This modem is ordered separately.
at "VT790 / LTE slot modem", "LAN, GSM, LTE, RADIUS, DNS, SSL, VPN".
7. USB ports are needed for USB camera recording, USB Flash for system logs, and for the system restore. Read instructions
at " ", " ", " ", "Connecting USB camera USB camera settings. How to save a video Saving system logs on USB flash drive USB
".upgrade or restore of default settings
a. " " - type micro USB-port 2.0, required to connect a USB camera.USB 0
b. " " - type USB-port 2.0, required to connect a USB camera or a USB Flash card.USB 1
8. " " - MicroSD card slot with an ejector. The card is needed for data storage or for the "system restore". Read SD card
instructions at " ", " ".Saving system logs to SD card Restore of the appliance (for VT960 series)
9a. " " - digital connector RJ12 for the connection of CAN sensors/extensions/devices on a CAN bus. Modules can CAN DEVICES
be chained together. Read instructions at " ", " ".CAN devises connection Setting up CAN
" " - green LED indicates CAN bus status.LED: CAN
The LED blinks slowly - nothing is connected
The LED blinks fast - configuration is in process
The LED glows constantly - connected to CAN devices
11. " " - accuracy +/- 1 °C.TEMPERATURE SENSOR
12. " " - green LED indicates appliance system status,LED: ACT
- operating mode of the device: switches at a frequency of 2 times per second;
- successful completion of the software update process: switches at a frequency of 4 times per second;
" " - The button can be programmed from the interface for alarm indicating.LED: ALARM
" " - red LED indicates error and traffic.LED: ERR
the operating mode of the device: If everything is normal, the LED is extinguished, if not - there's a constant glow;
software update mode: switches at a rate of 2 times per second;
