WAGO I/O System 750 Table of Contents 3
750-1505 16DO 24VDC 0.5 A, low-side switching
Manual
Version 1.1.0
Pos: 5/ D ok ume nt ati on allg em ein /V erz eic h nis se /I nhal ts ver z eic hni s - Ü b ers chri f t oG und V erz ei ch nis @ 3\mod_1219151230875_21.docx@21063 @ @ 1
Table of Contents
1Notes about this Documentation .............................................................5
1.1 Validity of this Documentation.................................................................5
1.2 Copyright................................................................................................5
1.3 Symbols .................................................................................................6
1.4 Number Notation ....................................................................................8
1.5 Font Conventions ...................................................................................8
2Important Notes ........................................................................................9
2.1 Legal Bases............................................................................................9
2.1.1 Subject to Changes............................................................................9
2.1.2 Personnel Qualifications ....................................................................9
2.1.3 Use of the 750 Series in Compliance with Underlying Provisions.......9
2.1.4 Technical Condition of Specified Devices.........................................10
2.1.4.1 Disposal ......................................................................................10
2.1.4.1.1 Electrical and Electronic Equipment........................................10
2.1.4.1.2 Packaging...............................................................................11
2.2 Safety Advice (Precautions) .................................................................12
3Device Description..................................................................................15
3.1 View .....................................................................................................17
3.2 Connectors...........................................................................................18
3.2.1 Data Contacts/Local Bus..................................................................18
3.2.2 Power Jumper Contacts/Field Supply ..............................................19
3.2.3 Push-in CAGE CLAMP®Connectors................................................21
3.3 Display Elements..................................................................................22
3.4Operating Elements..............................................................................22
3.5 Schematic Diagram ..............................................................................23
3.6 Technical Data .....................................................................................24
3.6.1 Device..............................................................................................24
3.6.2 Communication................................................................................24
3.6.3 Supply..............................................................................................24
3.6.4 Outputs ............................................................................................24
3.6.5 Connection Type..............................................................................25
3.6.6 Climatic Environmental Conditions...................................................25
3.7 Approvals .............................................................................................26
3.8 Standards and Guidelines ....................................................................27
4Process Image.........................................................................................28
5Mounting..................................................................................................29
5.1 Mounting Sequence..............................................................................30
5.2 Inserting and Removing Devices ..........................................................31
5.2.1 Inserting the I/O Module...................................................................31
5.2.2 Removing the I/O Module ................................................................32
6Connect Devices .....................................................................................33
6.1 Connecting a Conductor to the Push-in CAGE CLAMP®......................33
