wallas 270 Original operating instructions

Instructions 4.4.2007
Wallas-Marin Oy, Kärrykatu 4, FIN-20780 Kaarina Finland
Tel. [phone] Fax [phone]
Business ID: 1999776 - 0. Registered place of business Helsinki
Quick installation instructions for
blower lid 270 with surface kit 110
Surface installation kit 110:
•Delivery includes following items:
1. back cover sheet, 1 pce
2. flexible exhaust pipe, L=520mm, 1 pce
3. ceramic isolation sleeve, 1 pce
4. plastic sleeve Ø8x24.5mm, 2 pcs
5. hose clip DIN 3017-1 20/32mm, 3 pcs
6. Screw DIN 7985 M4x16 A2, 4 pcs
7. Screw DIN 7985 M4x35 A2, 2 pcs

2
270 & 85DP:
Take the stove 85 way from frame:
•Disconnect the +12V power and fuel hose
•Open two screws from both sides (total four screws)
•Lift the stove carefully to the workbench, ceramic plate facing down.
Use newspaper or similar as padding on the bench.
•Open frame fixing screws, if necessary (see note at page 6)
Remove unnecessary parts..
•Open four screws [1]
•.. and remove the back profile [2].
•Save items, they are not used with blower lid 270.
Open..
Frame
fixing
screws

3

4
Installation of 270 blower unit:
•Put the blower unit [3] between the profiles
•And tighten M4x8 screws (4pcs) [4] (delivered with blower unit)

5
Connect the cable between 85DU and 270:
•Remove shortcut piece and connect the blower cable [5] to the
terminal
•Fix the cable to the bracket [6] with a cable tie (delivered with 270).
Please assure that the cable will not contact the tangential blower.
5
6

6
NOTE:
The installation kit may be used without the back side exit, if there exists a
option to install exhaust pipe i.e. vertically through the table surface. In that
case, you may jump to the section Modify the existing surface installation
case.
Connect the flexible exhaust pipe:
•Tighten two hose clamps [7]
•The insulation sleeve should reach to between the clamp and the
pipe (prevent unraveling)
7
7

7
•Put the remaining exhaust pipe on the sleeve. Push the third clamp
[9] tightly against the blower unit back sheet and tighten the screw.
Assure that the aluminum sleeve [10] is stationary.
9
10

8
Modify the existing surface installation case:
•Open four screws [11] from both ends.
•And remove the back profiles [12].
•Save items, they are not used with blower lid 270
Put the stove & blower unit to its place:
•Please careful with the stove: as both back profiles are missing, if the
en plates are bended out, the stove may fall down to workbench.
11
12
12

9
Add the back sheet:
•Put the back cover on its place and tighten four M4x12 screws
M4x12
Tighten..

10
Final installation:
•Reconnect the power cable and fuel hose
•Put the stove on its place and tighten four screws
•Connect the rest of the exhaust pipe to the sleeve
•Slide the lid to hinge profile [13] and
•connect it [14]
13
14
Tighten ..