Wanderer COLLOOLA User manual
PLU: 668683
COLLOOLA INSTANT TENT
6 PERSON
DESCRIPTION PIC QTY.
Flysheet
Inner Tent
Awning Pole
Steel Peg
Guy Rope
Carry Bag
1
1
2
13
2
1
Open buckle
Pitching
Cover the inner tent with fly sheet,
secure the fly to the leg pole with
hook and loop tapes and to the corners
with buckles.
Folding
To assemble the awning use the steel
poles and guy ropes provided. Pass the
pole spigots through the eyelets on each
corner of the door. Peg down with guy
ropes to secure the poles.
Then fold the poles together and tie it up.
Take off the flysheet and remove the pegs from
the ground.
Take out inner
tent and lay it on the ground.
same for all 4 corners.
section will slide into the bottom section. Do the
Press the button on the leg pole, the upper pole
Do the same for all 4 corners.
Unbutton the buckles, loosen the webbing in bottom.
Close buckle
o
ut inn
er
nd
lay
it
on
th
eg
rou
nd
“click”
c
k”
Pull the tent upright and slide the leg
poles outwards until you hear a click.
Locate the buckle at the bottom of
the pole and click together to secure.
Secure the bottom corners of the
tent to the ground by inserting the
steel pegs
Warning
Before using the tent for the first time, it is recommended to check all components have
been included and you become familiar with the assembly of the tent by reading through
the instructions first.
DO NOT set up near open flame. The fabric will burn if left in continuous contact with
any flame source.
DO NOT use any form of flame or fuel burning appliances, heaters, candles or matches
inside or under the canopy of the tent.
Ensure your site is free from any objects and obstructions by checking the area and
clear away any rocks, tree branches or any sharp objects prior to setting up your tent.
Keep away from any overhead power lines and do not set up under trees where there is
the potential for either falling branches or lightning strikes to occur.
Tent must be securely pegged to the ground using all the peg points provided. All guy
ropes attached to the tent must be used at all times to create added stability and avoid
possible damage to either property or persons. It is crucial to do this anytime you have the
tent up to minimize the impact of unexpected wind gusts.
Be cautious when handling the frame. Avoid pinching hands or fingers in any moving
parts.
not hang any object
heavier than 2kgs. Check the hook every time before use. Do not use if it comes loose!
When removing the pegs from the ground, never pull on the tent to remove. This may
cause damage to either property or persons. Always pull on the peg itself.
This tent is not designed to be a permanent or semi-permanent structure. It is designed
to be used as a portable and temporary structure.
Care and maintenance
The following are some helpful tips on how to clean and properly store your tent.
Wash frame and canopy with a mild solution of soap and water, rinse thoroughly. Dry
completely. Do not use bleach or solvents.
DO NOT spray insecticides or bug repellant directly or near any fabric. This may damage
the water-repellant treatment.
Always return the tent to the carry bag after use. Be sure the tent is completely dry
before storing it.
Never store the tent wet. If the tent is wet, please take out from storage bag as soon as
possible and leave spread out to dry completely before storing away.
Due to cold air outside and warm air inside, the tent may develop condensation on the
inside of the tent. This is a natural event and adequate ventilation will help minimise this.
Manufactured & packaged for SRGS PTY LTD
ABN 23 113 230 050
6 Coulthards Avenue, Strathpine QLD 4500, Australia
Made in China
This manual suits for next models
1
Other Wanderer Tent manuals
