1•888•557•3848
wards.com 7
6
How to Use How to Use (cont.)
ASSEMBLING THE WHEELS
1. Assemble each wheel to a wheel mount by pushing the wheel post up into the
large hole at the bottom of each wheel mount.
2. Attach each wheel mount and wheel to the vacuum by sliding the wheel
mounts into the slots at the bottom of the vacuum base.
USING THE DRY VACUUM
1. Place the fabric barrel lter into the base. The ring of the lter should rest on
the top rim of the base.
2. Set the motor housing on top of the base, aligning the locks, and push down
until locks click into place.
3. Attach the hose to the suction port on the front of the base. Turn the hose
counterclockwise to lock it in place.
4. Attach a tool and/or extension rod(s) to the free end of the hose, if desired.
5. Make sure the vacuum switch on the motor housing is OFF.
6. Plug the power cord into an electrical outlet.
7. Press the switch to the ON position and vacuum as needed.
8. When nished, press the switch to OFF and unplug the cord from the outlet.
9. Pinch the side locks and remove the motor housing. Empty debris into a trash
receptacle after every use.
USING THE WET VACUUM
1. DO NOT use the barrel lter in the base.
2. Slide the sponge lter over the buoy cage on the center underside of the
motor housing.
3. Set the motor housing on top of the base, aligning the locks, and push down
until locks click into place.
4. Attach the hose to the suction port on the front of the base. Turn the hose
counterclockwise to lock it in place.
5. Attach a tool and/or extension rod(s) to the free end of the hose, if desired.
6. Make sure the vacuum switch on the motor housing is OFF.
7. Plug the power cord into an electrical outlet.
8. Press the switch to the ON position and vacuum as needed.
9. When the base is full of liquid, the buoy (in the cage on the underside of the
motor housing) will rise and discontinue suction of the vacuum (see diagram
on page 7).This will result in a noticeable change of sound of the motor and the
vacuum may shake to let you know the base is full. Press the switch to OFF and
unplug the cord from the outlet.
The raising water level raises the buoy.
Buoy cage (on
underside of
motor housing)
USING THE VACUUM AS A BLOWER
1. DO NOT use the barrel lter in the base.
2. Set the motor housing on top of the base, aligning the locks, and push down
until locks click into place.
3. Attach the hose to the exhaust/blower port on the back of the motor housing.
Turn the hose counterclockwise to lock it in place.
4. Attach a tool and/or extension rod(s) to the free end of the hose, if desired
5. Make sure the vacuum switch on the motor housing is OFF.
6. Plug the power cord into an electrical outlet.
7. Press the switch to the ON position and use as a blower.
8. When nished, press the switch to OFF and unplug the cord from the outlet.
10. Pinch the side locks and remove the motor housing. Empty liquid from the
base.
11. When nished vacuuming, press the switch to OFF and unplug the cord from
the outlet. Remove the motor housing and empty liquid after every use.
WARNING: To avoid overheating, DO NOT use this vacuum continuously for
longer than 30-minute increments.
WARNING: ALWAYS move the vacuum using the handle. DO NOT pull it by
the cord or hose.
