WatchNet ENS-08 POE Instruction Manual

QUICK CONNECTION GUIDE
Connecting Your ENS-08 POE
Package Contents:
LAN / WAN
Free DDNS
www.dvrid.com
NVR (X1) Cameras (X4 or x8) Remote Control (x1) Software CD (X1) Mouse (X1) Power Adaptor (X2) Ethernet Cable (X1) Power Cable (X2)
PoE
48 Volts Power
12 Volts Power
Router*
Microphone*
Speaker*
Smart Phone*
720P/1080P VGA*
Simultaneous Display
IE / Client for Windows or MAC Client for OSX
PoE IP Cameras Power
ON/OFF
USB Mouse
WatchNET Products are subject to continuous changes and
improvements, information on this document is subjected to
change without prior notice.
2015 WatchNET Inc. © All Rights Reserved
Quick Start Guide (X2) Mouse Pad (X1)
110V AC / 240V AC
720P/1080P HDMI*
Simultaneous Display
LAN
Typical 16 Camera connection
with built-in 8 Port POE NVR & 16 Port Switch
ENS 16 POE*
POE Cameras
Strobe lamp*
NOTE:
1. External 12 or 16 Port POE Switch is needed to connect the additional 8 cameras.
(If using regular switch, the cameras must have 12V 1Amp Power Source connected)
2. Launch the Config tool from the software CD and assign IP Address to cameras to suite the
local LAN configuration.
3. Please see hardware manual on the software CD for more instructions.
NOTE:
Cameras included only
in KIT Models and may vary from
KIT Model numbers
* Not included/sold separately.

EASY START-UP WIZARD
When first booting up the
NVR, Start-up Wizard will
initiate. Clicking "next step"
will start the Wizard.
Cancel to exit
Use the mouse to navigate
thru the setup
Login
Systems Default
Username: admin
Password: 1234
System Settings
Adjust the time and date. Click "Save" before moving to the next step.
Network
Change the default network to match the local network. Ask the network
administrator for the proper IP address, Gateway and Subnet Mask.
Click Next Step when done
Save Date & Time
adjustments
Remote Device (Connecting IP Cameras)
MPIX cameras will auto-enroll, will be assigned an IP and camera number
Defaults:
Cam 1 will be assigned to 10.1.1.65
Cam 2 will be assigned to 10.1.1.66
Cam 3 will be assigned to 10.1.1.67
Cam 4 will be assigned to 10.1.1.68
Set Recording Schedule
User can choose what the NVR records. Normal, Alarm,
Motion or all events
By default all NVRs are set to record motion detection 24/7
Camera Number
Hours of the day
Days of the week
Recording
Color Codes
Click Next Step and Close the Wizard.
Now the system is setup
and ready for recording.
1
Step
2
Step
3
Step
4
Step
5
Step
www.watchnetinc.com