Way Basics Wall Cube User manual

Thank You!
What’s
Included
Turn this page over to get started!
Thank you for choosing Way Basics! With your help, Way Basics products are helping protect the environment. No
new trees were cut down to create our furniture, because it’s made from recycled paper. At the end of its long life we
hope you’ll find other uses for our zBoards or simply recycle – then they might eventually find their way back to Way
Basics where we’ll make them into new zBoards!
Dowel x16 Vertical zBoard x2 Horizontal zBoard x2
Backboard x1
(with metal fitting)
Wall Attachment x2 Plastic Anchor x6
Screws x6 Drilling Template x1 Glue x1
Hook bracket guide
(28.5 x 28.5 cm)
Hook bracket guide
(50 x 28.5 cm)
Connect
With Us [e-mail] Share Your Photos and Win
www.waybasics.com/share

Apply glue into the pre-drilled holes and insert
dowels into horizontal zBoards and backboard.
Images below are for the Wall Cube. The Wall Rectangle is the same process
Remove protective strips on
horizontal zBoards and backboard.
Assemble the horizontal zBoards and
backboard.Notice that the metal fitting
needs to be on the back.
Assemble the vertical board.Level the guide sticker and stick it
on the wall
Drill 6 holes at center of the ovals
Insert anchors into holes Fasten hook brackets to wall anchors
with screws
Hang the assembled wall cube on the
hook brackets
1 2 3
4 5 6
7 8 9