WBM 6405D User manual

Features
The product is powered by an 18650 lithium battery with a capacity
of 1200mAh;
The grid voltage is about 3000V when working;
After the electric mosquito swatter is stopped, it has the function of
automatically eliminating the residual electricity of the high-voltage
net surface;
The product is equipped with 6 mosquito trapping purple lights, with
selected wavelength is 360-400nm;
The product has a power display function (the power is 25% when
one light is on,the power is 50% when two lights are on, the power
is 75% when three lights are on, and the power is 100% when four
lights are on).
The product has overcharge, overdischarge, overcurrent, and load
short circuit protection, etc., to accurately detect the charging
voltage to ensure the safety of charging.
Contact Us
54 HWY 12, Flemington
NJ 08822 USA 1-866-802-9366
www.wbminternational.com
User Manual
Read the instructions for use carefully
and keep them safe.
For the rst use, please push the power
switch to the "OFF" position and continue
charging for 4-6 hours.
2 IN 1
ELECTRIC BUG ZAPPER
Tips:
Keep away from children. Do not touch the metal
mesh while charging. It is strictly prohibited to use
in the environment of combustible gas, inflammable
and explosive articles and hazardous chemicals.
Working
IndicatorLight
300 x 145 mm 100g 双胶纸 正面
背面

2 IN 1
ELECTRIC BUG ZAPPER
Item NO. 6405D
Product instructions Precautions
When the electric bug zapper is working, the metal mesh surface
has high voltage! Keep away from children, beware of electric
shock to children,do not touch the metal mesh surface with your
hands or hand-held metal objects, high voltage danger, please pay
attention to safety!
Do not use this product in places where flammable gas or explosive
dust may exist, and do not often use metal and other conductive
objects to spark on the metal net;
After use, please push the power switch to the OFF position;
In order to guarantee the service life of the battery, if there is no
obvious effect of hitting the killing bug during use, or the bottom
battery power indicator flashes, it means that the battery power has
basically been used up.please stop using and recharge products in
time,When the voltage of the lithium battery is lower than 2.8V the
low-voltage protection function of the product will cause the product
to enter the protection state ano appear to be unable to work, and
it must be charged before use;
If it is not used for a long time, the product should be replenished
once every three months for about 4 hours The product should be
stored in a ventilated, dry place with a relative humidity of less than
80%. There should be no corrosive chemicals around;
Do not wipe with wet towels or rinse the bug corpses on the net
surface with water, you can use a soft brush with long hair or tap a
few times to fall off (bug carcass may cause a short circuit on the
meta mesh surface, damage the electric mosquito swatter, please
clear it in time);
Please do not slap other hard objects or pinch the mesh surface of
the product to avoid damaging the metal mesh surface;
Please operate in strict accordance with the requirements and
precautions of the instructions, and do not disassemble at will. The
company shall not be liable for any adverse consequences caused
by illegal operation.
Tips: Due to the built-in low-voltage protection function of the product, when the 25%
power indicator flashes or the power indicator does not light up on the product during use,
it means that the battery has basically run out. Please stop using and charge it in time.
And you need to push the power switch on the product to the "OFF" position to charge.
Conventional anti-bug method: Push the power switch on the right
side of the product to the ON1 position, press and hold the
high-voltage button switch, and the high-voltage working indicator
light will be on. At this time, the metal net is equipped with high-volt-
age, wave the electric bug swatter to make the metal net contact
with bug, and the bug will be killed immediately. When the button
switch is released, the work indicator goes off. At this time, there is
still residual voltage on the metal mesh. Do not touch the metal
mesh. The voltage will be automatically eliminated after a few
seconds;
Intelligent anti-bug method: Push the power switch of the product to
the ON2 position. At this time, the LED bug trapping purple light
glows, the grid has high voltage, and then insert the tail of the
electric bug swatter into the USB charging base of the product.
When mosquitoes and other harmful flying insects are attracted by
the purple light on the product and fly to the electric mosquito grid,
they will be killed when touched.When using the bug trap mode, the
connection of power supply is required to use the anti-bug light
function;
Turn OFF the anti-bug function ofthe product: Just push the power
switch to the OFF position
Working
Indicator Light
Working Indicator Light
High-voltage button switch
Charging base
Power switch
Press down to manually
kill mosquitoes
100% Power
75% Power
50% Power
25% Power
USB cable socket
Three layered safety mesh
Inside hidden
LED lamp beads
Mode selection
OFF / ON 1 / ON 2
Power Indicator Light
USB Cable
OFF
ON1
ON2
OFF
ON1
ON2
OFF
ON1
ON2
Shutdown State Bug Racket
Operation Mode
Insect Killing Lamp
Operation Mode
Rated charging voltage Output voltage
Rated capacity
Product Size
Rated charging current 1A
5V 3000V
1200mAh
Charging time 4H21.2 x 8.6 x 3.7 inch
Parameter
The Parts Subsidiary: Electric Bug Zapper /
USB Cable / Charging Base /
User Manual.