websense V10000 G3 User manual

Quick Start Guide
Websense V10000 G3
Web & Email Security Appliance
See the Rack Installation Instructions included in the
Sliding Ready Rail kit.
Contact Websense Technical Support if any items are missing.
Bezel (faceplate)
Power Cables (2) Documentation Disk Ethernet Cables (4)
Accessory Kit
1
Sliding Ready Rail Kit
2
• LeftReadyRail
• RightReadyRail
• VelcroStraps(2)
• RackInstallationInstructions
Cable Management Arm Kit
3
• CableManagementArm
• StaticSupportTray
• StatusIndicatorCable
• CableTieWraps
• CMAInstallationInstructions
Serial Cable
2
1
1. ConnecttotheapplianceviaserialportorKVMinordertoaccessthecommandlineinterfacefor
initial configuration. Serial port settings are: 9600 baud, 8 bits, no parity.
2. Secure power cables using velcro straps and plug power
cables into an appropriate power source.
12
1
2
12
Serial Connection KVM Connection
5Connect Input Device
Rack Appliance
Power on the appliance and check the following indicators:
Contact Websense Technical Support if any indicators are not
illuminated correctly.
Front
• Powerbuttonisilluminated.
• HarddriveLEDsaregreen.
Rear
• PowersupplyLEDsaregreen.
• LEDsforconnectedinterfaces(NICs)aregreen.
• Systemstatusindicator(LEDleftofpowersupplies)issolid
blue.
6Power On Appliance
PleaserefertotheV-SeriesApplianceGetting Started guide for
more details.
Initial Configuration
Appliance Command Line (firstboot script)
• Conguresecuritymode.
• CongureApplianceControllerinterface(C).
Appliance Manager
• AccesstheApplianceManagerviatheLogonPortal.
• CongureNTPservers/systemtime.
• Congureapplicablenetworkinterfaces.
Web Mode
TRITON Unified Security Center
• Entersubscriptionkey,updateMasterDatabase,congure
NetworkAgent,andcongurepoliciesinTRITON-Web
Security.
• RequiresWindowsServer2008R2.
Content Gateway Manager (proxy)
• Congureuserauthenticationandselectprotocols.
Email Mode
TRITON Unified Security Center
• Completecongurationwizard,entersubscriptionkey,and
congurepoliciesinTRITON-EmailSecurity.Congure
emailDLPpoliciesinTRITON-DataSecurity.
• RequiresWindowsServer2008R2.
Web and Email Mode
Perform steps above for Web mode followed by Email mode.
IfyoursitedoesnothaveaWebsenseproxy,skiptheContent
GatewayManagerconguration.
7Configuration Overview
Verify Contents
Plan your deployment before setting up the appliance. See the
back of this guide for a deployment overview and reference sheet.
Before you begin...
Theappliancesupportsthefollowingsecuritymodes:
3Determine Security Mode
Basedonyoursubscriptionanddeploymentplan,determinetheappropriatesecuritymodeforthis
appliance.
• Web(WebSecurityGateway/Anywhere)
• Email(EmailSecurityGateway/Anywhere)
• WebandEmail(EmailplusWebsenseWebSecurityorWebSecurityGateway/Anywhere)
12
P2 P1 E2 E1
CN
Connecttheapplianceinterfacesrequiredbythesecuritymodeforthisappliance.Cat 5E cables (or
better) are required. Do not use crossover network cables.
Provides access to the Appliance Manager, Content Gateway Manager, and the optional
on-board Web Security console.
4Connect Network Cables
QSG420-100_RevA
* The P1 interface is not used for Websense Web Security in this mode

Deployment Reference SheetAppliance Deployment Overview
Youcandeployoneormoreappliancesonyournetwork.Thediagrambelowillustratesabasicappliancedeployment.
AseparatecomputerwithWindowsServer®2008R2isrequiredforrunningTRITONUniedSecurityCenter.Seethe
V-SeriesApplianceGetting Started guide for details.
* P2 is optional and may be connected to a router or switch.
** Connecttobidirectionalspan,monitor,ormirrorportifsendingblockinginformationthroughN.
3
Internet
Firewall
Clients
Windows Server 2008 R2
Router
*
** Switch
TRITON Unified Security Center
Email Security
Web Security SQL Server
Policy Server IP: IP Address:
Log Server IP: User Name:
Subscription Key: Password:
Log Server IP:
Authentication Mode:
Network Configuration
Network Agent Interface (N)
Websense Content Gateway Interfaces (P1 & P2)
Email Security Gateway Interfaces (E1 & E2)
P1
E1
P2
E2
Appliance Controller Interface (C)
IP Address: Primary DNS:
Subnet Mask: Secondary DNS:
Default Gateway: Tertiary DNS:
IP Address: Primary DNS:
Subnet Mask: Secondary DNS:
Default Gateway: Tertiary DNS:
IP Address: Default Gateway:
IP Address: Default Gateway:
Subnet Mask: Primary DNS:
Subnet Mask: Primary DNS:
IP Address:
IP Address:
Secondary DNS:
Secondary DNS:
Subnet Mask:
Subnet Mask:
Tertiary DNS:
Above settings apply to P1 and P2
Tertiary DNS:
Above settings apply to E1 and E2
Getting Started Guide
www.websense.com/library/
Also available on the Documentation disk.
Online Support and Contact Information
support.websense.com
Support & Resources
Appliance Information
Logon Portal URL: Hostname:
admin is the default user name for Appliance Manager, TRITON Unified Security Center, and Content Gateway Manager.
SeetheV-SeriesApplianceGetting Started guide for details.