WellMike DX-A206 User manual

PIR Wireless Sensor
INCLUDE
PIR Wireless Sensor x 1pc
Bracket x 1pc
Screws x 2pcs
FEATU R E
Technology with PIR (Pyro-electric Passive Infra-Red ) motion sensor
PIR Wireless Sensor detects temperature changes in infra-red radiation
within the PIR coverage area
Once PIR Wireless Sensor detects a temperature change, it will be
triggered (red LED ON) and send a signal to the main unit that someone
or something is approaching
Up to 60 degree Horizontal & 6degree Vertical sensor angle up to 5
meter detected distance
OPEATION
1. Slide the bracket to the PIR Wireless
Sensor (see Drawing)
2. Follow the polarity instruction to install
3pcs of AA batteries, Alkaline is
recommended (not included)
3. Make sure the PIR Wireless Sensor has
successfully learned code with Main Unit
instruction

4. Mount the PIR Wireless Sensor to proper location you want to monitor,
such as, entrance, garage, stair, balcony, gate...etc.
5. When people walk by, PIR Wireless Sensor will be triggered (red LED ON)
and the Main Unit will be alarmed
NOTE
1. If battery power is weak, the PIR red LED will flash every 3 minutes to
remind the user to replace new battery
2. For best performance and distance, please keep the PIR Wireless Sensor
away from the metal objects
3. The PIR coverage and distance might be various from different
environment
4. The PIR sensor has a 3 seconds interval between each triggering
5. This product is designed for indoor use, so please keep away from water,
direct sun light or microwave
6. Mount your PIR Wireless Sensor higher to avoid miss-trigger by pets
7. This product is detecting temperature, so please keep away from heat to
avoid miss-triggering