WESTBRASS 493144HRHBJB User manual

Fine Decorative Plumbing Since 1935
WESTBRASS
Semi-Exposed Bathwaste
& Overflow
Desbordamiento de baño dren del tirón
ASME A112.18.1 / CSA B125.1
YOU MAY NEED:
USTED PUEDE NECESITAR:
Screwdriver
El destornillador
Tape measure
Cinta métrica
on screws.
Importante: Use cinta para
plomero en las tornillos.
Silicone Sealant: Use silicone
sealant under base of faucet.
Sellador de silicón: Si el
lavamanos está desnivelado use
sellador de silicón debajo de la
base del borde.
Pliers: For removal and instal-
lation.
Alicates: Para quitar y insta-
lación.
PVC Primer and Cement
PVC Cartilla y Cemento
Hacksaw
Sierra parra mentales
SILCONE
ABS Primer ABS Cement
1. Measure and dry t all connections.
Use Hacksaw to cut tubes as required.
2. Primer then glue drain elbow and female
adapter. Primer and glue elbow to tee
and adapter.
3. Apply a thin ring of silicone around the
underside of the strainer. Position gasket
between the drain ell and the bottom
of the bath. Begin threadng the strainer
into the drain ell.
493144HRHBJB
20 Ga. Brass Finished Top - 24”Ball Joint
Brass top and Sch.40 Horizontal tubes with
Brass Tip-Toe Drain Closure
and Extension
0.10”
2.750”
1.91”
1-1/2” NPSM
(1-7/8” - 11.5)
1-1/2” PVC
Solvent Weld
2.225”
2.675
11224201
®
UPC
1
-
1
/
2
”
S
C
H
4
0
3-5/8”
4-1/4”
FineDecorativePlumbing Since 193 5
WESTBRASS
1-1/2”
SCH 40
D
W
V
C
R
N
1
-
1
/
2
”
A
B
S
Finished
1-1/2”
1-1/2” Diameter
3” Diameter
4C-A
1/4”- 20
UNC-2A
x 1.75
529-1-3/4
2”
792BB-2
792RWT
D980-CAP
1/4”-20 UNC-2B
1-1/2”
SCH 40
D409
1-1/2”Flanged Nut
1536-ADAPTER
1-1/2” Insert
Male Adapter with
1-1/2”Swept Tee
1637-ELBOW
1-1/2”Sch.40
ABS Socket Weld
Sanitary Ell
442P
1-1/2“ ST
Female Adapter
2-7/8”
5/16”
1-1/2”OD Tubing
20 ga. Cut to Fit
Tub Dimensions
Dash # 332-3/16
Silicone, Buna-N or
EPDM O-Ring
792A-BJ
DASH 218 O-ring
1/8”Fractional
Buna-N or EPDM
Dash 220 O-ring
1/8”Fractional
Buna-N or EPDM
®
UPC
C
WB 17 GA
Glue Loctite 271
Threadlocker
24”
D980-RING
79338MOB
3/8” - 16
D398RB-F
1-5/8”- 16
Fine Thread
(D3323-2 or
793SOCPZ-F)
493144HRHBJB
Silicone
®
UPC
1
-
1
/
2
”
S
C
H
4
0
1. Medir y secar en forma todas las conexiones.
Use una sierra para cortar tubos según sea
necesario.
2. Imprimación luego pegamento drenaje codo
y hembra. adaptador. Primer y pegamento
codo a te y adaptador.
3. Aplica un anillo no de silicona alrededor de
la parte inferior del colador. Junta de posición
entre el codo del desagüe y el fondo
del baño. Empezar a enhebrar el colador.
en el desagüe ell.

Care Instructions
Care should be given to the cleaning of this product.
To Clean
Wipe gently with a damp cloth.
Blot dry with a soft towel.
Maintenance
If faucet leaks from spout:
Replace Ceramic Cartridge. URP33447 and URP33448
Remove and Clean Aerator
Install cartridges correctly for proper handle rotation:
For Lever handles, the stops must point to the right when
installed.
Instrucciones Sobre el Cuidado
Se debe tener cuidado con la limpieza de este producto.
Para limpiaria:
Frote con un Paño húmedo.
Séquela con una toalla sueve.
Mantenimiento
Cierre Los Suministros De Agua.
Si la llave tiene fugas en la salida:
Reemplace Cartucho de Cerámica, Equipo para Reparación
URP33447 y URP33448
Quite y limpie el aireador
Instale los cartuchos correctamente para una giración
correcta de la manija:
Para manijas de palanca, los topes deben se señalar a la
derecha cuando son instalados.
Drain and Strainer Finishes:
(01) PVD Polished Brass (26) Polished Chrome (07) Satin Nickel
(12) Oil Rubbed Bronze (50) PowderCoated W (62) PowderCoated Flat Black
CARE & MAINTENANCE
TO CLEAN:
Do not allow your product to come into contact with any cleansers forti-
Soft Scrub, Dawn Liquid Soap, Palmolive or any other combined cleaners
contain certain chemical components that will dissolve and remove the
warm water and mild soap on a soft cloth or sponge. Avoid using any
sponge with a scouring pad to clean your product. It is not necessary to
rub hard to remove spots.
and living, require some care in use.
WARRANTY
arofdetnarrawsistcudorpllafoytilanoitcnufehT
retawynanosevlavcsidcimareC.raeyonefodoirep
delivery merchandise are warranted for one year. Warran-
ties are guaranteed to the original purchaser only. Product
problems attributable to abuse, misuse, improper instal-
lation, hard water, neglected maintenance or accidental
damage are not covered by this warranty. Modifying the
product in any way voids the warranty. The use of plumb-
er’s putty on our products also voids the warranty. Silicone
sealing compounds should be used instead. No repairs
or replacements will be made under such circumstances
except at customer’s expense. Liability under warranties
expressed or implied is limited to repair or replacement of
defective goods only. In no event will Westbrass be liable for
incidental or consequential damages (such as labor charges).
This warranty does not cover labor charges, whether based on
breach of express or implied warranty, breach of contract,
negligence or any other legal theory.
TO PROTECT:
An occasional application of Carnauba wax
(without cleaners), like that found in Flitz Fau-
cet Wax, Turtle Wax for Clear Coat Car Finishes
or McGuire’s Premium Wax, will enhance the
Functional Warranty:
WESTBRASS • 2429 E. Olympic Blvd., Los Angeles, CA 90021
(213)-627-8441 • [phone] • or[email protected] • www.westbrass.com
WARRANTY
CARE INSTRUCTIONS
4. Inserte el mango de unos alicates en el
escurrir y asegurar el colador a ell retirar
Sellador en exceso.
5. Aplicar un cordón no de silicona alrededor.
Cara de la junta tórica de rebosamiento. Montar
el D980-ANILLO utilizando los tornillos
suministrados. Ajuste la rótula a los contornos de
la bañera y apretar el anillo.
6. Deslice el chapetón en el tubo y
extenderlo a través del suelo y en el
1536-ADAPTADOR.
7. Apretar los accesorios y roscar el rebosadero.
cubrir.
8. Compruebe si hay fugas.
4. Insert the handle of a pliers into the
drain and secure strainer to ell. Remove
excess sealant.
5. Apply a thin bead of silicone around
face of the overow O-ring. Mount the
D980-RING using the provided screws.
Adjust the ball-joint to the contours of
the tub and tighten the ring.
6. Slide the escutcheon onto the tube and
extend it through the oor and into the
1536-ADAPTER.
7. Tighten ttings, and thread on overow
cover.
8. Check for leaks