Westinghouse DA1084PT Playtime User manual

DA1084PT “Playtime” • DA1084BL “Bunny Luv”
Westinghouse, (W) and “YOU CAN BE SURE... IF IT'S WESTINGHOUSE” are
trademarks of Westinghouse Electric Corporation used under license by Salton, Inc
PHOTO FRAME BABY MONITOR

Thank you for purchasing this Baby Monitor with Picture Frame!
For proper set up and use, please read these instructions.
Please keep this instruction booklet for future reference
as it contains important information.
CONSUMER INFORMATION
Occasionally, a consumer may experience a problem with one of our products. If this
should happen, please call us toll-free, rather than return this product to the store.
Usually, we can solve the problem over the telephone or send you replacement parts.
Please call Westinghouse®Consumer Information at [phone].
TECHNICAL DATA
Channel 1 frequency: 49.830 MHz
Channel 2 frequency: 48.873 MHz
AC adaptor: 9 volt 100MA / 120v ~, 60 Hz
Transmitter battery: 9 volt Block / Alkaline (not included)
Receiver battery: 9 volt Block / Alkaline (not included)
The maximum operating distance is 150m (open area) in ideal conditions.
INSTRUCTIONS FOR USE
Power Options
This product includes two AC adaptors to power transmitter and receiver (plugs into stan-
dard household outlets – 120V AC). Both transmitter and receiver also run on DC battery
power (9V alkaline battery – not included).
Setup and Use
1. Connect the appliance plug of the power adaptor to the power supply bushes of the
transmitter and receiver.
2. Devices can also operate by DC battery power. Open the battery door and insert a
9V battery into the battery compartment.
Note: When the unit is operated by DC battery, if static is transmitted more
frequently, please replace battery with a fresh 9V alkaline battery.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed, including the following:
1. Read all instructions.
2. Keep a distance of at least three feet between transmitter and child when using the
system for baby monitoring.
3. This system cannot replace responsible adult supervision of a child or person
requiring care, but act only as a support!
4. This product is not intended to be used as a medical monitor and its use should not
replace adult supervision.
5. Test sound reception of receiver before first-time use and whenever you change the
location of the transmitter.
6. To prevent entanglement:
◆ Never place transmitter in a crib or playpen. Keep transmitter and receiver out of
baby’sreach.
◆ Never use extension cords with the AC adaptor.
7. Never use transmitter or receiver near water (i.e., bathtub, sink, laundry tub, wet
basement, etc.).
8. Always use transmitter and receiver where there is adequate ventilation. To prevent
overheating, keep transmitter and receiver away from heat sources such as radiators,
heat registers, directsunlight, stoves, amplifiers, or other appliancesthat produce heat.
9. Excess dirt in transmitter microphone will hamper transmission of sound. Clean outer
surface of transmitter and receiver with a cloth lightly dampened with a mild cleaning
solution.
10. Never immerse transmitter, receiver, or AC adaptors in water.
BATTERY SAFEGUARDS
◆ Remove the battery during long periods of non-use. Always remove an exhausted
battery from the product. Battery leakage and corrosion can damage this product.
Dispose of battery safely.
◆ Do not dispose of battery in a fire. The battery may explode or leak.
◆ Never short circuit the battery terminals.
◆ A non-rechargeable battery is not to be recharged.
◆ If removable rechargeable battery is used, it is only to be charged under adult supervision.
◆ A rechargeable battery is to be removed from the product before it is charged.
◆ If you use a battery charger, it should be examined regularly for damage to the cord,
plug, enclosure and other parts. Do not use a damaged battery charger until it has
been properly repaired.
SAVE THESE INSTRUCTIONS — For Household Use Only
This product cannot replace responsible adult supervision.
g
!
CAUTION

Picture Frame
You may insert a photo (approximate size 5.79" x 3.78") into the transmitter and a photo
(approximate size 2.28" x 1.73") into the receiver.
Inserting Photos
Transmitter:
◆ Press and push the two OPEN knobs at the bottom and open the panel.
◆ Insert a photo and fix it into the frame.
◆ Press the front panel back against the rear case until you hear a click.
Receiver:
◆ Simply slide in a photo from the top of the frame.
PROBLEMS AND SOLUTIONS
Problem Solution
Transmitter power indicator is not lit. Check if power supply has been
connected and the power switch
has been turned on.
Receiver power indicator is not lit. Check if power supply has been
connected and the power switch
has been turned on.
You hear static or buzzing from the receiver. 1. Make sure channel switches on
both transmitter and receiver are
set to the same channel.
2. Receiver is out of transmission
range.
Note: Range varies depending on
surrounding conditions such
as noise levels, physical
obstructions and signal
interference.
Hints
◆ Do not use more than one transmitter and one receiver at the same time in the same
household.
◆ Always remember that you are using public airways when using your monitor.
Conversations, even from rooms near transmitter, may broadcast to other nursery
monitors, radios, cordless telephones, or scanners outside of your home. To protect
privacy in your home, always turn transmitter off when not in use.
3. Make sure to connect the power supply
(either AC poweror DC battery)before use.
4. Set transmitter channel switch (located on
back panel above the AC adaptor) to the
same channel as receiver.
5. Turn on the power of the transmitter. The
RED power indicator lights.
6. Turn on the power of the receiver. The
RED power indicator lights (one of five
LEDs shown on the front of the
transmitter).
Testing Sound Reception
Test transmitter transmission and receiver
reception each time you change location of use.
1. Place transmitter in room in which you
intend to use it. Turn on the transmitter
power. Turn on a radio for testing
assistance.
2. Place receiver in room in which you intend
to use it, or carry it along with you (if oper-
ating in DC power mode). Turn on the
receiver power. Adjust the volume level by
rotating the volume switch.
3. Variable light display will light when sound is received by receiver.
4. Keep the units away from other electronic appliances to avoid interference.
Note: If buzzing or static can be heard on the channel selected in the receiver, switch
both units to the other channel. Selecting a channel is usually a one-time adjustment.
Since transmission takes place on the 49 MHz frequency range, other baby moni-
tors or radio installations might use the same frequency, disturbance can occur on
rare occasions. In this case, please change the channel. Disturbances due to other
radio installations are not a device fault and are unavoidable.
Tips
On Transmission: When sound is detected by the built-in microphone, the transmitter unit
starts transmitting automatically. The transmission stops when sound is no longer detected.
On Receiver: When the receiver is not receiving sound signals, the four RED receiver indi-
cators (not including the power light) go out and the loudspeaker is silent. If the sound
quality is too poor, the signal might be blocked. In this case, move the receiver unit closer
to the transmitter unit to restore sound reception again.

Limited One Year Warranty
Warranty: This Westinghouse®product is warranted by Salton, Inc. to be free from defects in materials or work-
manship for a period of one (1) year from the original purchase date. This product covers only the original consumer
purchaser of the product.
Warranty Coverage: This warranty is void if the product has unreasonable use, misuse, neglect, improper service,
commercial use, repairs by unauthorized personnel, normal wear and improper assembly, installation or mainte-
nance abuse or other causes not arising out of defects in materials or workmanship. This warranty is effective only
if the product is purchased and operated in the USA. Warranty does not extend to any units which have been used
in violation of written instructions furnished with the product, or to units which have been altered or modified, or to
damage to products or parts thereof which have had the serial number removed, altered, defaced or rendered illeg-
ible.
Implied Warranty: ANY IMPLIED WARRANTIES WHICH THE PURCHASER MAY HAVE ARE LIMITED IN DURATION
TO ONE (1) YEAR FROM THE DATE OF PURCHASE. Some states do not allow limitations on how long an implied
warranty lasts, so the above limitation may not apply to you.
Warranty Performance: During the above one-year warranty period, a product with a defect will be either repaired or
replaced with a reconditioned comparable model (at our option) when the product is returned to the Repair Center,
or the purchase price refunded. The repaired or replacement product will be in warranty for the balance of the one-
year warranty period and an additional one-month period. No charge will be made for such repair or replacement.
Service and Repair: Should the appliance malfunction, you should first call toll-free [phone] between the hours of
9amand 5pmCentralStandardTimeandaskforCONSUMERSERVICEstating thatyouare aconsumerwith aproblem.
Please refer to model number DA1084PT “Playtime” or DA1084BL “Bunny Luv” (as appropriate) when you call.
In-Warranty Service (USA): For an appliance covered under the warranty period, no charge is made for service or
postage. Call for return authorization [phone].
Out-of Warranty Service: A flat rate charge by model is made for out-of-warranty service. Include (US) for return
shipping and handling. We will notify you by mail of the amount of the charge for service and require you to pay in
advance for the repair or replacement.
For Products Purchased in the USA, but Used in Canada: You may return the product insured, packaged with sufficient
protection, and postage and insurance prepaid to the USA address listed below. Please note that all customs
duty/brokerage fees, if any, must be paid by you and we will require you to pay the cost of customs duty/brokerage
fees to us in advance of our performing any service.
Risk During Shipment: We cannot assume responsibility for loss or damage during incoming shipment. For your
protection, carefully package the product for shipment and insure it with the carrier. Be sure to enclose the following
items with your appliance: any accessories related to your problem, your full return address and daytime phone
number, a note describing the problem you experienced, a copy of your sales receipt or other proof of purchase
to determine warranty status. C.O.D. shipments cannot be accepted.
To return the appliance, ship to: To contact us, please write to, call, or email:
Attn: Repair Center Salton, Inc.
Salton, Inc. P.O. Box 1637
708 South Missouri Street Columbia, MO 65205-1637
Macon, MO 63552 [phone]
Email: [email protected]
Limitation of Remedies: No representative or person is authorized to assume for Salton, Inc. any other liability in
connection with the sale of our products. There shall be no claims for defects or failure of performance or
product failure under any theory of tort, contract or commercial law including, but not limited to: negligence,
gross negligence, strict liability, breach of warranty and breach of contract. Repair, replacement or refund shall be
the sole remedy of the purchaser under this warranty, and in no event shall Salton be liable for any incidental or
consequential damages, losses or expenses. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.
Legal Rights: Thiswarranty givesyouspecific legalrights,and you may alsohave other rights which vary from state tostate.
Westinghouse, (W) and "YOU CAN BE SURE... IF IT'S WESTINGHOUSE" are trademarks of Westinghouse
Electric Corporation used under license by Salton, Inc.
For more information on Salton products: visit our website at www.eSalton.com.
© 2003 Salton, Inc. All Rights Reserved Printed in China
FCC NOTE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reason-
able protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television receptions,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
◆ Reorient or relocate the receiving antenna.
◆ Increase the separation between the equipment and receiver.
◆ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
◆ Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user’s authority to operate the equipment.
Playtime Baby Monitor
Model Number: DA1084PT
–and –
Bunny Luv Baby Monitor
Model Number: DA1084BL
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Playtime Baby Monitor or Bunny Luv Baby Monitor
Salton, Inc.
P.O. Box 1637
Columbia, MO 65205-1637
[phone]
Email: [email protected]