Westwood Design Geneva User manual

Assembly Instructions
Geneva Convertible Crib
Toddler Guard Rail
W
westwood design

WARNING
<
FAILURE TO FOLLOW THESE WARNINGS AND ASSEMBLY INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH.
<
READ ALL INSTRUCTIONS BEFORE ASSEMBLING CRIB. KEEP INSTRUCTIONS FOR
FUTURE USE.
<
PREVENT BURNS. KEEP BED AWAY FROM OPEN FIRES AND OTHER HEAT SOURCES.
<
ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27-1/4 IN. (69 CM.) BY 51-5/8
IN. (131 CM.), WITH A THICKNESS NOT EXCEEDING 6 IN. (15 CM.). THE DIMENSIONS
OF THE MATTRESS SHOULD BE TAKEN FROM SEAM TO SEAM.
<
THE MINIMUM AGE OF THE INTENDED USER SHALL NOT BE LESS THAN 15 MONTHS
AND THE MAXIMUM WEIGHT SHALL NOT BE GREATER THAN 50 LBS.
(22.7 KG)
<
PROVIDED GUARDRAIL MUST BE USED.
<
DO NOT PLACE BED NEAR WINDOWS WHERE CORDS FROM DRAPES OR BLINDS
MAY STRANGLE A CHILD.
<
DO NOT PLACE ITEMS WITH A STRING, CORD, OR RIBBON AROUND A CHILD’S NECK,
SUCH AS HOOD STRINGS OR PACIFIER CORDS.
<
DO NOT SUSPEND STRINGS OVER A TODDLER BED FOR ANY REASON.
IMPORTANT!
<
CHECK THIS PRODUCT FOR DAMAGED HARDWARE, LOOSE JOINTS, MISSING PARTS
OR SHARP EDGES BEFORE ASSEMBLY AND PERIODICALLY DURING USE. DO NOT
USE CRIB IF ANY PARTS ARE MISSING, DAMAGED OR BROKEN. CONTACT
WESTWOOD DESIGN: 635 N. BILLY MITCHELL RD., STE. B, SALT LAKE CITY, UTAH
84116, PHONE: [phone]; EMAIL: [e-mail] FOR
REPLACEMENT PARTS AND INSTRUCTIONS IF NEEDED. NEVER SUBSTITUTE PARTS.
!

Step 1
A. Using the allen wrench, remove the six bolts attaching the footboard to the
crib and remove the footboard.
Required Hardware
Allen Wrench
Allen Bolt (O)

Step 2
A. Screw the removable feet (included with the crib) into the bottom of the crib sides.
B. Adjust the spring to its lowest position, following the procedure shown in these instructions.
C. Use the bolts you removed from the footboard (O) to attach the guard rail to the crib. Tighten
securely using the allen wrench.
D. Insert the allen bolt (P) through the top hole in the corner post, and thread it into the cap nut
(Q) as shown. Tighten securely using the allen wrench. Repeat for the other side.
Required Hardware
4 x Allen Bolt, 2” Long (O)
Allen Wrench
Removable Foot (C)
Allen Bolt (P)
2 x Allen Bolt, 1-1/8” Long (P)
2 x Cap Nut (Q)
Allen Bolt (O)
Cap Nut (Q)

Mattress Height Adjustment
The toddler bed can only be used with the mattress support in its lowest position.
To adjust the mattress height, follow these steps:
A. Carefully tip the crib onto its back.
B. Undo the four wing nuts holding the support arms to the spring and remove
the screws.
C. Lower the spring to the desired setting and align the holes.
D. Insert the screws and tighten the wing nuts.
Highest
Lowest
Middle
Wing Nut
Support Arm
635 N. Billy Mitchell Rd., Ste. B
Salt Lake City, UT 84116
Phone: [phone]
[e-mail]
May 10, 2011
W
westwood design