manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. Wet Sounds
  6. •
  7. Subwoofer
  8. •
  9. Wet Sounds ZERO Series User manual

Wet Sounds ZERO Series User manual

ZERO SERIES
Sealed Enclosure Subwoofer
Owner’s Manual
Wet Sounds ZERO Series Sealed Enclosure Subwoofer Owner’s Manual
Thank you for choosing this Wet Sounds™product!
Wet Sounds is synonymous with live, loud, and clear audio solutions, built
to serve the needs of the marine and powersports enthusiast. The ZERO
Series is a rst of its kind innovation for Wet Sounds, taking the legendary
REV tower speaker performance and reimagining it for optimal use in
more conned spaces.
The high output in small, sealed enclosures means ZERO Series allows for
ZERO compromises. These speakers can also be used with or without a
twist-lock grille, making them ideal for both custom and OEM replacement
applications. The ZERO Series speakers and subwoofers utilize materials
such as Nylas, a composite of nylon and berglass, providing improved
stability and superior strength versus conventional speaker materials.
Please take a moment to read the instruction manual before starting
your installation. The guide will explain the benets of the technologies
developed by Wet Sounds and will help you understand the correct
installation methods and use of this product. If you have any questions or
concerns, please contact a certied Wet Sounds dealer. You may also
contact Wet Sounds technical support by dialing 1-877-WET-SPKR (1-877-
938-7757).
Congratulations!
Wet Sounds ZERO Series Sealed Enclosure Subwoofer Owner’s Manual
2
Table of Contents
Please take a moment to look over this instruction manual
before enjoying the product.
Technology Specications ..................................................... 3
Installation Specications ........... ........................................ 4-5
Limited Warranty ......................................................................6
3
ZERO 10 SPEAKER SPECIFICATIONS
Fs: 30Hz
Qms: 6.00
Qes: .56
Qts: .52
Vas: 35.2 L
Sd: 369.8 cm2
Xmax: 8.2 mm
RMS: 300W
Peak: 600W
Impedance: 4Ω
Frequency Response: 30Hz - 2kHz
Sensitivity: 84.5 dB at 1W/m
Diameter: 11.16” w/grille
Mounting Depth: 3.57”
Hole Cut Out: 9.24”
Weight: 9.8 lbs (4.4 kg)
Recommended Sealed Enclosure: .5 ft3
Technology Specications
ZERO 12 SPEAKER SPECIFICATIONS
Fs: 28Hz
Qms: 6.00
Qes: .59
Qts: .54
Vas: 68.4 L
Sd: 534.8 cm2
Xmax: 9.7 mm
RMS: 400W
Peak: 800W
Impedance: 4Ω
Frequency Response: 25Hz - 2kHz
Sensitivity: 85.9 dB at 1W/m
Diameter: 13.43” w/grille
Mounting Depth: 3.72”
Hole Cut Out: 11.14”
Weight: 13.2 lbs (5.9kg)
Recommended Sealed Enclosure: 1 ft3
ZERO 10
ZERO 12
11.16” 3.57” 1.44”
9.24”
13.43”
11.14”
3.72” 1.66”
Wet Sounds ZERO Series Sealed Enclosure Subwoofer Owner’s Manual
4
Installation Specications
Continued on next page.
Wet Sounds ZERO Series Sealed Enclosure Subwoofer Owner’s Manual
Tape the surrounding surface to prevent damaging the finish, and avoid
cutting outside the cut line to prevent improper fitment.
For speaker alignment, the terminal indicates the bottom of the speaker, and
the opposing lock tabs help for horizontal alignment.
Pre-drill the screw locations to
prevent surface cracking.
Fasten the speaker with stainless
steel 3/16” x 1.5” Phillips screws.
Place the grille on the speaker in a
45° angle.
Apply downward pressure on the
grille and twist clockwise to lock.
We recommend checking if the mounting surface is flat with a square or level.
Mounting to a curved surface will damage the product.
4
5
3
6
2
1
7
Connect the speakers to the amplifier with the waterproof connector provided.
8
45°
Top
lock tab lock tab
Bottom
mounting surfacemounting surface
4 Ohms 400W
Recommended:
5/32 drill bit
5
Installation Specications
Note: ZERO Series has a standard Deutsch connector compatible connection.
(PN: DT04-2P) PIN 1 (+) PIN 2 (-)
Wet Sounds ZERO Series Sealed Enclosure Subwoofer Owner’s Manual
Tape the surrounding surface to prevent damaging the finish, and avoid
cutting outside the cut line to prevent improper fitment.
For speaker alignment, the terminal indicates the bottom of the speaker, and
the opposing lock tabs help for horizontal alignment.
Pre-drill the screw locations to
prevent surface cracking.
Fasten the speaker with stainless
steel 3/16” x 1.5” Phillips screws.
Place the grille on the speaker in a
45° angle.
Apply downward pressure on the
grille and twist clockwise to lock.
We recommend checking if the mounting surface is flat with a square or level.
Mounting to a curved surface will damage the product.
4
5
3
6
2
1
7
Connect the speakers to the amplifier with the waterproof connector provided.
8
45°
Top
lock tab lock tab
Bottom
mounting surfacemounting surface
4 Ohms 400W
Recommended:
5/32 drill bit
2 1
Limited Warranty
What This Warranty Covers
This is a “Limited” warranty. This warranty covers any defects in materials and workmanship and
the warranty only applies to the original purchaser and is not transferable. This warranty is only
valid if the original purchase was made from an authorized Wet Sounds dealer.
How Long Coverage Lasts
This warranty runs for 2 years from the date of the purchase.
What Is Not Covered
This warranty does not cover fading or discoloration caused by exposure to sunlight or
chemicals such as ammonia, household bleach, or any cleaning material that contains
abrasive substances. For information on how to prevent fading or discoloration, consult
recommendations on cleaning products. Wet Sounds, Inc. does not cover the cost for removal
and reinstallation of any kind. Additionally, shipping to Wet Sounds, Inc. is covered by the
purchaser. This warranty is void and inapplicable if Wet Sounds deems that the product was
abused or misused; including but not limited to Speaker product that has been improper-
ly-powered (under or over powered), causing thermal (burnt voice coil) and/or mechanical
failure (torn surrounds or spiders), damage caused by accident, mishandling, improper
installation, negligence, normal wear and tear, excessive water or heat damage, freight
damage or products that have been altered in any way. (The warranty is not transferable and
will neither apply to products purchased from unauthorized dealers nor product owned by
anyone other than the original purchaser from an authorized Wet Sounds dealer.) Wet Sounds
is not responsible for any damages to a consumer’s boat or person from a product failure. The
warranty is void if Wet Sounds deems the product was installed or used improperly. Wet Sounds
shall not be responsible for any incidental or consequential damages, except to the extent
provided (or prohibited) by applicable law. This warranty gives you specic legal rights, and
you may also have other rights which vary by state.
What Wet Sounds, Inc. Will Do
Wet Sounds, Inc will repair any part of your product that proves to be defective in materials or
workmanship. In the event repair is not possible, Wet Sounds, Inc. will replace the product in
question. If it is deemed necessary, Wet Sounds, Inc. will either replace the entire product with
a refurbished unit or it will be replaced with a model that is similar in price if that model is no
longer available. Labor cost and materials needed to complete this service will be at no
charge to the purchaser. Additionally, the cost of shipping to the consumer is also covered
under this warranty.
How to Obtain Warranty Service
Contact Wet Sounds, Inc. either by phone at 877-938-7757 or by email at
[email protected]. A service representative will assist you in the necessary actions to
verify that the problem that you are experiencing is covered under warranty. If it is in fact a
warranty issue, Wet Sounds will issue an RA number for tracking purposes and give instructions
on sending the product in for evaluation.
How State Law Applies
This warranty gives you specic legal rights, and you may also have other rights which vary from
state to state.
Internet Warning
Wet Sounds, Inc. products sold on any unauthorized website or internet auction site are void
of any and all manufacturer’s warranty. Please contact Wet Sounds at 877-938-7757 or visit our
website at www.wetsounds.com to search for an authorized site and/or an authorized retailer
near you.
Caution & Respect
Wet Sounds speakers can achieve very high sound pressure levels. Please use this product
responsibly. Be aware that sound travels great distances across water so please respect other
boaters especially while loading/unloading at the ramp or dock. Wet Sounds, Inc. is not
responsible for any violations of the law that may be a direct result of excessive volume.
Please abide by the rules but have fun doing it.
6
Wet Sounds ZERO Series Sealed Enclosure Subwoofer Owner’s Manual
Wet Sounds, Inc.
www.wetsounds.com
877-938-7757
2975 Louise Street
Rosenberg, Texas 77471 USA
© 2022 Wet Sounds, Inc. All Rights Reserved. WET SOUNDS and associated logos where
applicable are registered trademarks of Wet Sounds Corporation in the United States and/or
other countries. All other trademarks are the property of their respective owners.
ZERO SERIES

This manual suits for next models

2

Other Wet Sounds Subwoofer manuals

Wet Sounds SS-10B User manual

Wet Sounds

Wet Sounds SS-10B User manual

Wet Sounds SS-10B 24 User manual

Wet Sounds

Wet Sounds SS-10B 24 User manual

Wet Sounds REVO V3 User manual

Wet Sounds

Wet Sounds REVO V3 User manual

Wet Sounds REVO 10 / 12 FA SERIES User manual

Wet Sounds

Wet Sounds REVO 10 / 12 FA SERIES User manual

Wet Sounds SS-65 User manual

Wet Sounds

Wet Sounds SS-65 User manual

Wet Sounds REVO XXX-12 User manual

Wet Sounds

Wet Sounds REVO XXX-12 User manual

Wet Sounds VENUE Series User manual

Wet Sounds

Wet Sounds VENUE Series User manual

Wet Sounds ST-AS 10 Operating instructions

Wet Sounds

Wet Sounds ST-AS 10 Operating instructions

Wet Sounds XS-12 User manual

Wet Sounds

Wet Sounds XS-12 User manual

Wet Sounds HT-AS-10 Service manual

Wet Sounds

Wet Sounds HT-AS-10 Service manual

Wet Sounds XS-XXX User manual

Wet Sounds

Wet Sounds XS-XXX User manual

Popular Subwoofer manuals by other brands

IMG STAGE LINE PSUB-215 instruction manual

IMG STAGE LINE

IMG STAGE LINE PSUB-215 instruction manual

BASSFACE IndyS8/2 instruction manual

BASSFACE

BASSFACE IndyS8/2 instruction manual

Cambridge Sound Works MegaWorks 210D user manual

Cambridge Sound Works

Cambridge Sound Works MegaWorks 210D user manual

PureLink CSW620 instruction manual

PureLink

PureLink CSW620 instruction manual

Sound Storm USS8 user manual

Sound Storm

Sound Storm USS8 user manual

Sunfire SDS-8 quick start guide

Sunfire

Sunfire SDS-8 quick start guide

Audiodesign Hifonics MBP1000.4 installation guide

Audiodesign

Audiodesign Hifonics MBP1000.4 installation guide

JVCKENWOOD KFC-W2541 manual

JVCKENWOOD

JVCKENWOOD KFC-W2541 manual

TRU Audio cSUB-8 user manual

TRU Audio

TRU Audio cSUB-8 user manual

Eton MOVE 10-300AR instruction manual

Eton

Eton MOVE 10-300AR instruction manual

JBL P1222 Specification sheet

JBL

JBL P1222 Specification sheet

Power bass 4XL-151D Application guide

Power bass

Power bass 4XL-151D Application guide

Vandersteen Audio 2WQ Operation manual

Vandersteen Audio

Vandersteen Audio 2WQ Operation manual

Canton 03724 AS 2020 SC operating instructions

Canton

Canton 03724 AS 2020 SC operating instructions

Genesis SERVOSUB S4/8 Setup and owners manual

Genesis

Genesis SERVOSUB S4/8 Setup and owners manual

Nady Audio ProPower PSW18 Features, instructions & technical data

Nady Audio

Nady Audio ProPower PSW18 Features, instructions & technical data

BassBoss VS21-MK3 user manual

BassBoss

BassBoss VS21-MK3 user manual

JL Audio Stealthbox SB-T-TACDCG3/10TW3 installation guide

JL Audio

JL Audio Stealthbox SB-T-TACDCG3/10TW3 installation guide

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.