Whirlpool ADG 689 User manual

Whirlpool is a registered trademark of Whirlpool USA 5019 396 96013
GB
ADG 689 Quick Reference Guide
Before using the dishwasher, read the user instructions!
(We reserve the right to make technical modifications)
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
“Eco Dry” button
Press the button to active drying using the
energy-saving ventilation system.
“Delayed start” button
The wash cycle can be programmed to start after
1-12 hours. Then press the Start button. After a
prewash the set delay will start.
Display
The display shows all the information relating to
the functions selected.
1) Reference programme for energy label in compliance with EN 50242 (the
reference cycle refers to a cycle with the “Eco Dry” function selected);
2) Refer to “User instructions“;
3) Programme data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15° C - as well as water hardness
and power supply voltage, etc.
4) Programmes with “Eco Dry” last approx. 30 min. more.
Programme ON/OFF selector knob
First press and release the selector knob to access it,
and then turn it to select the desired programme;
the dishwasher switches on.
To switch off the dishwasher when the programme
has finished, turn the selector knob to off.
Start button
Press to start the wash cycle and keep pressed until
an acoustic signal confirms the start of the wash
cycle. The display shows the approximate duration
of the wash cycle.
Note: the light above the start button blinks during
the wash cycle.
The light stops blinking and remains alight to
indicate the cycle has ended (“End” on the display)
or has been interrupted due to a fault
(“E1, E2....” on the display).
Indicators
Options
Programme chart Eco
Dry Detergent 2) Consumption 3)
Programmes Loading instructions A B Litres kWh Minutes
P1 Pre-Rinse cold Crockery to be washed later. - - - 5.0 0.02 9
P2 Delicate 4) 45°C Light soiling, for example glasses and cups X X - 12.0 0.90 79
P3 Rapid 30 min 45°C Lightly soiled crockery with no dried-on food. - X - 13.0 0.35 30
P4 Normal 4) 65°C Normally or heavily soiled crockery. X X X 17.0 1.18 100
P5 Universal 4) 65°C Normally or heavily soiled crockery. X X - 13.0 1.23 100
P6 Bio 4) 55°C Normally or lightly soiled crockery, with dried-on food X X X 17.0 1.08 108
P7 Eco 1) 4) 55°C Normally soiled crockery. X X - 13.0 1.01 160
P8 Intensive 4) 70°C Recommended programme for heavily soiled crockery,
especially suitable for pans and saucepans. X X X 20.0 1.48 125
3GB96013.fm Page 1 Wednesday, September 15, 2004 2:34 PM
Black process 45.0° 100.0 LPI

How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Large compartment A
Small compartment B
Mechanical indicator lamp C.
Electric indicator on control panel (if provided).
On models with water softener system
only.
Mechanical indicator lamp D.
Electric indicator on control panel
(if provided).
Refer to the dishwasher loading instructions.
Press and turn the selector knob to select the desired programme and
switch on the appliance.
If necessary (and if provided).
The corresponding indicator lamp lights up.
“Cancel”
Press and hold the “Start” button
until the indicator lamp stops
blinking and stays on.
Press and hold the “Start” button
for 10 seconds. “P0” will appear on
the display and the programme will
stop.
“Change programme in progress”
Press and hold the “Start” button
until the indicator lamp stops
blinking and stays on.
Select and start the programme as
described previously.
- Only open the dishwasher if
necessary (Warning: beware of hot
steam).
- If the appliance is switched off
during a wash cycle, when
switched on again it will resume
the cycle from where it was
interrupted.
To switch off the dishwasher turn the selector knob to off.
All the indicator lamps and the display switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Open the door
How to fill the detergent
dispenser A
BC
Check the rinse aid level
Check the
regeneration salt level
D
Load the racks
Close the door,
select a programme
Select
additional options
Press the Start button
to start the programme
(during the cycle the
Start indicator blinks)
Turn on the water tap
Wash cycle
Switch off the appliance
Turn off the water
tap, unload the racks
3GB96013.fm Page 2 Wednesday, September 15, 2004 2:34 PM
Black process 45.0° 100.0 LPI

Dishwasher loading instructions and racks provided
Upper rack: depending on the model
Crockery holder (A):
Depending on the position: up or
down.
Long-handled utensils, cups and
glasses. Place the glasses to the
side of the rack or holders.
Place long and narrow utensils in
the centre of the rack or holders.
Long-handled utensils (e.g.
carving forks, knives) must be
arranged with the sharp end
facing in towards the appliance.
Rack height adjustment:
Release the caps (B) of both rack
rails.
Take the rack out.
Reposition the rack at the desired
height.
Close the caps (B).
The rack must be level on both
sides.
Lower rack:
Depending on the model with fixed
or tilting plate holders.
Cutlery basket:
Some models are provided with a
grid (C) that can be fitted onto the
cutlery basket to keep items
separated.
Sharp knives and forks that might
cause injury must be placed in
the cutlery basket with the sharp
end facing downwards.
Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a
dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver
cutlery.
A
AA
A
B
B
CC
CC
3GB96013.fm Page 3 Wednesday, September 15, 2004 2:34 PM
Black process 45.0° 100.0 LPI

What to do if...
If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see
also the corresponding chapter in the user instructions).
Problem Cause Remedy
The appliance is not
working • No water supply. • Open the tap.
• The appliance does not load sufficient
water. • Clean the water supply tap filter. • Ensure there are no kinks in the water hose.
• There is a power failure. • Insert the plug into the mains socket.
• Open the door.
• Close the door.
• Check the domestic circuit fuse.
If crockery is not
perfectly dry • Insufficient rinse aid. • Increase dosage *.
• Residual water in cavities. • Load crockery at an angle.
If crockery is not
perfectly clean • The water jet does not reach the
crockery. • Arrange crockery so that items do not touch each other. Load crockery upside down.
• Insufficient detergent. • Follow recommended detergent dosage.
• Unsuitable programme. • Select a more intense wash cycle.
• Spray arms blocked. • The spray arms must be able to turn freely.
• Spray arm nozzles clogged. • Remove any impurities obstructing the water flow *.
• Incorrect detergent/detergent too old. • Use a good quality detergent.
Sandy or grainy residues • Clogged filters. • Check filters regularly/if necessary clean *.
• Filters incorrectly assembled. • Insert the filter correctly *.
Colour of plastic parts
faded • Tomato/carrot juice,... • Depending on the material, if necessary use a
detergent with a greater whitening power.
Deposits on crockery
•removable • Streaks on the crockery/glasses. • Reduce the rinse aid dosage *.
• Layer of salt on crockery/glasses. • Close the salt container lid properly *.
•notremovable • Insufficient water softening, calcium
deposits. • Change water hardness setting, if necessary add salt *.
Opaque glasses/
glasses not sparkling • Cannot be washed in the dishwasher. • Use suitable glasses.
Rust on cutlery • Not made of stainless steel. • Use suitable cutlery.
See the user instructions for the troubleshooting table with possible faults.
If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water
supply tap, then call our After-Sales Service (see guarantee).
Before contacting our After-Sales Service, take note of the following:
• The nature of the fault.
• The appliance type and model.
• The service code (the number indicated on the adhesive rating plate)
inside the door on the right-hand side.
3GB96013.fm Page 4 Wednesday, September 15, 2004 2:34 PM
Black process 45.0° 100.0 LPI