Quick Reference Guide GB
Crockery holders:
•Down: cups and long-stemmed
glasses.
•Up: plates.
Cutlery holder for long utensils:
•Up: glass holder (gently lift up and
release).
•Down: large cutlery (gently lift up).
•Place knives with blades facing
downwards.
Glass holder:
•The glass holder can be moved
sideways.
•Below: small glasses.
•Above: long-stemmed glasses.
Half load button / Multizone:
If only the upper rack is to be loaded,
remove the cutlery basket from the
lower rach and place it in the upper one.
Height adjustment:
(The dishwasher is delivered with the
upper rack in the top position).
The rack height can also be changed
when loaded.
•To lower: pull out the two side
handles and gently lower the rack.
•To raise: pull up the two side
handles until the rack clicks into
place.
•The rack must be level on both
sides.
Lower rack
Half load button / Multizone:
Loading the lower rack only
gives greater washing power,
especially for plates and saucepans.
Cutlery basket:
The cutlery basket can be removed to
increase available space.
Plate holders:
•The plate holders may be removed
to increase available space.
•To remove: pull the handle up.
•To reposition: simply insert in the
required position (normal or
crosswise).
Daily check list
1. Arrange crockery so that items do
not touch each other.
2. Load cups at an inclination to
facilitate water circulation.
3. In general, place the cutlery in the
basket with the handles positioned
downwards, but ensure that sharp
knives and forks that might cause
injury are placed in the basket with
the handles positioned upwards.
4. Make sure the water jet can reach
all loaded items and that the spray
arms turn freely.
5. Turn on the water supply tap before
starting the dishwasher.
Important
•Switch off the dishwasher once the
“Start”indicator lamp has
switched off. If you switch off the
dishwasher during a wash cycle,
when switched on again the
dishwasher resumes the cycle from
where it was interrupted.
•If a fault occurs or you wish to
change the current programme,
press the “START”button for about
5 seconds until the Start indicator
lamp switches off ! Refer to the
“Troubleshooting Guide”in these
user instructions to remedy any
problems.
•If regeneration salt is to be
added, IMMEDIATELY start a
washing programme, to
eliminate any residual salt.
•Sometimes even when the
regeneration salt container is full,
the corresponding indicator
lamp may illuminate during the
first wash cycle.
Upper rack
