Whirlpool 6MT 744/WH User manual

WHIRLPOOL CONSUMER SERVICES Models 6MT 744/WH
June 2001
Copyright © 2000 Whirlpool (Australia) Pty. Limited
All rights strictly reserved. Reproduction or issue to third parties in any form whatsoever is
not permitted without written authority of Whirlpool (Australia) Pty. Limited
Whirlpool is a registered trademark of Whirlpool U.S.A.
This documentation is intended only for qualified technicians who possess the required qualifications and
are aware of the regulatory requirements applicable to servicing electrical appliances.
Whirlpool (Australia) Pty Limited Part No. SM7031
A. C. N. 003 578 023
WHIRLPOOL AUSTRALASIA
CONSUMER SERVICES
SERVICE MANUAL
CRISP GRILL MICROWAVE OVEN
Model 6MT 744/WH
Version 8538 744 53781

WHIRLPOOL CONSUMER SERVICES Models 6MT 744/WH
Page 2 of 8
CONTENTS
INTRODUCTION SAFETY 3
TECHNICAL DATA 4
ERROR CODES 4
EXPLODED VIEW 5
PARTS LIST 6 - 7
CIRCUIT DIAGRAM 8

WHIRLPOOL CONSUMER SERVICES Models 6MT 744/WH
Page 3 of 8
INTRODUCTION SAFETY
INTRODUCTION
Before leaving the factory each oven is carefully checked.
It must, however, be installed and used correctly.
Despite all the steps taken to make the oven safe, the safety is dependent on the correct installation and the fact the
user understands how to use and maintain the oven.
The information in this section should be used as a reminder that the oven is safe and that anyone who uses it must
first read the instructions for use in order to be able to use the oven correctly and obtain best results.
SAFETY
To avoid injury to yourself and damage to the appliance always work to the following rules when servicing an oven.
Always disconnect the plug from the mains before starting work.
If there is no plug switch off the electric supply at the control box.
When you have finished servicing an and oven before you reconnect it to the mains, make sure that:
- all the internal connections are correct
- the wires are insulated and not touching the door or the cabinet or anything sharp
- all the earth connections are electrically and mechanically sound
-do not modify or anyway interfere with the safety devices built-in to the oven
Make sure that each replacement part you use conforms to the manufacturer's specifications
Do not start a repair if you have any doubt as to your ability to complete it.
CAUTION - MICROWAVE RADIATION
PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE FROM THE
MAGNETRON, WAVEGUIDE OR ANTENNA IF THEY ARE IMPROPERLY USED OR CONNECTED. ALL INPUT
AND OUTPUT MICROWAVE CONNECTIONS, WAVEGUIDES, FLANGES AND GASKETS MUST BE SECURE.
NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE ENERGY ABSORBING LOAD ATTACHED.
NEVER LOOK INTO AN OPEN WAVEGUIDE OR ANTENNA WHILE THE DEVICE IS ENERGISED.
NEVER OPERATE AN OVEN WITH CABINET OFF WITHOUT MEASURING THE MICROWAVE LEAKAGE
AROUND MAGNETRON AND VISIBLE MICROWAVE CONNECTIONS (WELDING JOINTS).
Do not operate the oven if the following conditions exist:
- the door does not close firmly against the door support because of the door being warped or the hinges
damaged.
- The door trims or seals are damaged.
- If there is any visible damage to the oven.
- if the door does not close properly.
Avoid operating the oven if known components in the interlock system, oven door or microwave generating
assembly are known defective. They must be replaced.
WARNING - HIGH VOLTAGE
IT IS POSSIBLE TO COME IN CONTACT WITH LETHAL HIGH VOLTAGE WHEN WORKING WITH
HV TRANSFORMER, HV CAPACITOR AND MAGNETRON. THEREFORE NEVER TRY TO MEASURE THE HIGH
VOLTAGE. ALWAYS TAKE UTMOST CARE WHEN PERFORMING ELECTRIC
MEASUREMENTS INSIDE THE OVEN.

WHIRLPOOL CONSUMER SERVICES Models 6MT 744/WH
Page 4 of 8
TECHNICAL DATA
Dimensions of cabinet Height : 320 mm
Width : 530 mm
Depth : 450 mm
Dimensions of cavity Height : 205 mm
Width : 330 mm
Depth : 370 mm
Weight Net : 20 kg
Gross : 23 kg
Electrical Voltage : 230 - 240 V
Frequency : 50 Hz
Power Output power : 800 W
Grill : 900 W
Microwave frequency :2450 MHz
Timer : 5 sec. to 90 min.
ERROR CODES
Certain fault conditions are indicated by an error code.
The following codes are included in the self diagnostic functions:
Note : Not all codes are included in all models.
ERR 0 Convection temperature sensor fault.
Not connected or short circuit.
ERR 1 Short circuit in the MW relay.
ERR 6 Weight sensor calibration has not been performed.
ERR 7 Humidity sensor is defect or has not been connected.
ERR 8 Impossible to write to E 2 PROM.
ERR 9 Options have not been set.
ERR A No wheel detected on weight sensor.
ERR B No pulses from the weight sensor or <4267 Hz.
ERR C Fuzzy temperature sensor fault. Not 19-41 °C.

WHIRLPOOL CONSUMER SERVICES Models 6MT 744/WH
Page 5 of 8
EXPLODED VIEW

WHIRLPOOL CONSUMER SERVICES Models 6MT 744/WH
Page 6 of 8
PARTS LIST
Item Part No Description
001 0 4819 442 38913 Cabinet, Black
010 0 4812 310 38447 Mounting kit, Stainless steel
011 0 4819 462 79423 Foot
041 0 4819 417 19547 Hinge left
041 1 4819 417 19548 Hinge right
041 2 4812 535 98059 Shaft hinge
044 0 4819 492 68886 Spring
044 1 4819 404 79353 Support
110 0 4812 498 78099 Handle
117 0 4819 498 78366 Handle for crisp plate
120 0 4812 459 48087 Frame
121 0 4819 442 38917 Door, inner metal part
121 1 4819 535 38153 Lock door
130 0 4819 404 79332 Unit, pushbutton for door switch
234 0 4819 325 18122 Plate / Holder
234 1 4819 462 38878 Casing
244 1 4819 466 89229 Cover for food
246 0 4819 418 79915 Tray
255 0 4819 466 78405 Turntable
264 0 4819 535 79159 Rail
264 1 4819 462 38767 Crosspiece
301 0 4812 276 38059 Button assy
305 0 4819 404 79555 Holder
320 0 4812 453 19914 Panel, control
332 2 4819 410 29162 Button clock-set
333 0 4812 410 28663 Button start-stop
334 3 4812 410 78095 Button Defrost
334 4 4819 411 29817 Knob timer
334 6 4819 410 29171 Button tt-stop
334 7 4812 410 28715 Button plus
334 8 4812 410 78097 Button minus
352 0 4819 130 38083 Display
355 0 4819 280 18029 Buzzer
404 0 4819 131 58019 Magnetron
404 1 4819 462 38875 Conveyor
404 2 4819 462 38874 Air guide
406 0 4819 361 18381 Motor, Turntable
411 0 4819 148 68076 Transformer electronics
412 0 4819 145 78207 Transformer, HT 230V
420 0 4819 121 18299 Capacitor 1,15m F-2100V
420 1 4819 404 78839 Bracket capacitor
421 0 4819 121 18162 Filter, mains
426 0 4819 121 18265 Diode HV
442 0 4819 361 18361 Motor Blower
442 1 4819 462 38876 Cap fan

WHIRLPOOL CONSUMER SERVICES Models 6MT 744/WH
Page 7 of 8
PARTS LIST (Cont.)
Item Part No Description
442 2 4819 462 38877 Inlet fan
443 0 4819 515 28224 Fan wheel
452 0 4819 259 98596 Infrared element 450W 120V
452 1 4819 325 18123 Reflector
485 0 4819 320 28025 Cable, HT
490 0 4819 321 18242 Cable, mains
500 0 4812 214 78391 Control unit
505 0 4812 209 88006 Microprocessor
531 0 4819 101 48142 Potentiometer
561 0 4819 282 48281 Thermostat for magnetron 125 °C
564 0 4819 282 48275 Thermostat 165 °C
617 0 4819 280 68363 Relay 24V DC
617 1 4819 280 68321 Relay
622 0 4819 276 18273 Switch VKS
622 3 4819 276 18448 Switch turntable stop
633 0 4819 276 18336 Switch, door
651 0 4819 134 88199 Lamp oven
774 0 4819 442 38914 Cover, Mica plate upper
774 1 4819 462 88031 Cover, Mica large lower
794 0 4819 532 68686 Gasket ring for Turntable
910 0 4819 502 18372 Screw for Turntable Motor
910 2 4819 502 38274 Screw M4x16St
971 0 4819 252 28125 Fuse T10A
972 0 4819 252 28121 Fuse T100mA

WHIRLPOOL CONSUMER SERVICES Models 6MT 744/WH
Page 8 of 8
CIRCUIT DIAGRAM