Whirlpool AVM 515 WH User manual

SERVICE Whirlpool Europe
Customer Services
Model AVM 515 WH
Version 8538 515 64291 Page
Introduction safety 2
Technical data 3
Spare part list 4
Exploded view 5
Wiring diagram 6
Service Manual
Microwave oven
AVM 515 WH
AVM 515 WH
This documentation is only intended for qualified technicians who are aware of the respec-
tive safety regulations.
Date: 30.07.2001 Subject to modification
Document-No.: 4812 714 13913

SERVICE
30.07.2001 / Page 2 AVM 515 WH Whirlpool Europe
Doc. No: 4812 714 13913 8538 515 64291 Customer Service
Introduction safety
INTRODUCTION
Before leaving the factory each oven is carefully checked.
It must, however, be installed and used correctly.
Despite all the steps taken to make the oven safe, the safety is dependent on the correct installation and the fact
the user understands how to use and maintain the oven.
The information in this section should be used as a reminder that the oven is safe and that anyone who uses it must
first read the instructions for use in order to be able to use the oven correctly and obtain best results.
SAFETY
To avoid injury to yourself and damage to the appliance always work to the following rules when servicing an oven.
Always disconnect the plug from the mains before starting work.
If there is no plug switch off the electric supply at the control box.
When you have finished servicing an oven before you reconnect it to the mains, make sure that:
- all the internal connections are correct
- the wires are insulated and not touching the door or the cabinet or anything sharp
- all the earth connections are electrically and mechanically sound
- do not modify or anyway interfere with the safety devices built-in to the oven
- make sure that each replacement part you use conforms to the manufacturer´s specifications
Do not start a repair if you have any doubt as to your ability to complete it.
CAUTION - MICROWAVE RADIATION
PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE FROM THE MAGNETRON,
WAVEGUIDE OR ANTENNA IF THEY ARE IMPROPERLY USED OR CONNECTED. ALL INPUT
AND OUTPUT MICROWAVE CONNECTIONS, WAVEGUIDES, FLANGES AND GASKETS MUST BE SECURE.
NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE ENERGY ABSORBING LOAD ATTACHED.
NEVER LOOK INTO AN OPEN WAVEGUIDE OR ANTENNA WHILE THE DEVICE IS ENERGIZED.
NEVER OPERATE AN OVEN WITH CABINET OFF WITHOUT MEASURING THE MICROWAVE LEAKAGE
AROUND MAGNETRON AND VISIBLE MICROWAVE CONNECTIONS (WELDING JOINTS).
Do not operate the oven if the following conditions exist:
- the door does not close firmly against the door support because of the door being warped or the hinges damaged.
- The door trims or seals are damaged.
- If there is any visible damage to the oven.
- if the door does not close properly.
Avoid operating the oven if known components in the interlock system, oven door or microwave
generating assembly are known defective. They must be replaced.
WARNING - HIGH VOLTAGE
IT IS POSSIBLE TO COME IN CONTACT WITH LETHAL HIGH VOLTAGE WHEN WORKING WITH
HV TRANSFORMER, HV CAPACITOR AND MAGNETRON. THEREFORE NEVER TRY TO MEASURE
THE HIGH VOLTAGE. ALWAYS TAKE UTMOST CARE WHEN PERFORMING ELECTRIC
MEASUREMENTS INSIDE THE OVEN.

SERVICE Whirlpool Europe AVM 515 WH 30.07.2001 / Page 3
Customer Service 8538 515 64291 Doc. No: 4812 714 13913
Technical data
Dimensions of cabinet
Height 297 mm
Width 492 mm
Depth 383 mm
Dimensions of cavity
Cavity volume 22 l
Electrical
Voltage 230 V
Frequency 50 Hz
Power consumption 1330 W
Current consumption 6.5 A
Power
Output power microwave 800 W
Microwave frequency 2450 MHz
Timer
mechanical 60 min.
5-level microwave power level

SERVICE
30.07.2001 / Page 4 AVM 515 WH Whirlpool Europe
Doc. No: 4812 714 13913 8538 515 64291 Customer Service
Spare part list
Model AVM 515 WH
Service No. 853851564291
Version 853851564291
Pos. No. 12NC Code Description
001 0 4819 902 00561 Lid
002 2 4819 902 00568 Plate,mica
002 3 4819 902 00571 Pin
002 4 4819 902 00569 Bushing for pin,mica plate
011 0 4819 902 00694 Foot
011 1 4819 902 00566 Cap
040 0 4819 902 00445 Hinge,upper
040 1 4819 902 00444 Hinge,lower
121 0 4812 902 08011 Door body assy
121 1 4812 450 58409 Door frame inner
130 0 4819 902 00579 Holder
131 1 4819 902 00013 Pin
131 3 4819 902 00597 Hook connector
131 4 4819 902 00594 Pivot door pin
133 0 4819 902 00596 Lockingmechn. upper
133 1 4819 902 00595 Lockingmechn. lower
142 0 4819 450 58454 Glass inner (PE plate)
143 0 4812 459 48035 Door plastic cover
143 1 4812 450 58191 Plate front pc
255 0 4819 902 00654 Turntable glass
264 0 4812 462 38111 Ring turn table
264 1 4819 902 00582 Wheel
264 2 4819 902 00114 Shaft
320 0 4812 453 58798 Panel
321 0 4812 381 18239 Display
331 0 4812 310 48114 Knob set
332 0 4812 410 28608 Button
404 0 4819 902 00843 Magnetron
406 0 4819 902 00695 Motor turn table
406 3 4819 902 00567 Gasket
412 0 4812 145 38029 Transformer HV
412 9 4819 902 00322 Rubber spacer
420 0 4812 121 58135 Capacitor HV
421 0 4819 902 00075 Control unit mainsfilter
426 0 4819 218 38038 Diode HV
440 0 4819 902 00696 Propeller,motor
443 0 4812 515 28069 Fan wheel (six blade)
443 1 4819 902 00591 Support fan
490 0 4819 902 00298 Cable,mains SAA Plug
490 4 4819 902 00563 Clip wire sadle
490 5 4819 902 00604 Strain relief
490 6 4819 404 79411 Bracket for cable
503 0 4819 902 00602 Timer
561 0 4819 902 00586 Thermostat magnetron
562 0 4819 902 00573 Thermostat oven 80 ˚C
632 0 4819 902 00651 Microswitch monitor
632 1 4812 902 08009 Lever
633 0 4819 902 00611 Switch interlock/monitor
651 0 4819 134 28051 Lamp
743 0 4819 902 00575 Air guide magnetron
900 5 4819 902 00585 Holder filter board
904 0 4819 902 00589 Sleeve
910 9 4819 902 00565 Pin
930 0 4812 492 48166 Spring
930 1 4819 902 00598 Spring door lock
Pos. No. 12NC Code Description
930 3 4812 902 08008 Spring

SERVICE Whirlpool Europe AVM 515 WH 30.07.2001 / Page 5
Customer Service 8538 515 64291 Doc. No: 4812 714 13913
Exploded view

SERVICE
30.07.2001 / Page 6 AVM 515 WH Whirlpool Europe
Doc. No: 4812 714 13913 8538 515 64291 Customer Service
Wiring diagram