Whirlpool 3LA5580XS User manual

AUTOMATIC
WASHER
Suoye;Capacity
3LA5580XS
.,.,
Microwave Ovens. Trash Compactors. Room Air Conditioners. Oehumldiflers. Automatic Washers, Clothes Dryers. Freezers, Refrqeralor-Fr

Contents
Page
PARTS AND FEATURES . Page
2 For a Rinse and Spin 10
IMPORTANT SAFETY For a Drain and Spin 10
INSTRUCTIONS. . . 3 MAGIC CLEAN@ Lint Filter . 10
OPERATING INSTRUCTIONS.. 4 CARING FOR YOUR WASHER 11
Starting Your Washer 4 Winterizing,, 12
What Happens in Each Cycle 6 IF YOU NEED SERVICE OR
OTHER OPERATING ASSISTANCE 13
INSTRUCTIONS . . 10 WASHER WARRANTY.. 16
01987 Whirlpool Corporation
Parts and features
LOADLOAD
SIZESIZE l.AUNDRlLAUNDRY
INFORMATION
INFORMATI,.. TEMPERATURE MAGIC CLEAN @
.- .... m-m.-..- LINT FILTERLINT FILTER
(not shown)
KNOB
ODE1 AND SERIAL
NUMBER PLATE
Remove the Consumer
Buy Guide label. It will be
easier to remove before the
washer is used.
You should wipe out the
basket with a damp cloth
before using to remove dust
from storing or shipping.
Model and Serial Numbers here
When you need service or call with a
question, have this information ready:
1. Complete Model and Serial Numbers Model Number
(from plate under the lid near the serio, Number
2. Purchase date from sales slip.
Copy this information in these spaces. Pur6hoseb9te
Keep this book, your “Laundry Guide” and
sales slip in the Laundry Information
Center. Service Company
Phone Number
Please complete and mall the Owner Registration Card turnished with
thlr product.
2

Additional Safety Instructions and Your Responsibilities
ALWAYS store detergent, laundry aids ALWAYS unplug the power supply
and other materials in a cool, dry cord before attempting to service the
place where children can’t reach washer.
them- in a locked cabinet if possible. DO NOT machine wash glass fiber
ALWAYS read and follow instructions materials. Small particles can stick to
on packages of detergent and laun- fabrics washed in following loads
dry aids - especially warnings and and cause skin irritation.
precautions. You are personally responsible for
HAZARDOUS FUMES can be formed if
chlorine bleach is used in the same
wash as ammonia or acids such as
vinegar or rust remover.
making sure that your washer:
l is used only for jobs normally ex-
pected of home automatic washers.
l is not run by children or anyone un-
able to operate it properly. 3

Operating instructions
Starting Your Washer
Be sure to measure and add detergent, then place
a sorted load in the washer before starting it.
1 2
Select
n Select a LOAD SIZE . WATER TEMPERATURES
l Turn the knob to point at a setting
that describes the size of load you
want to wash.
l Set the knob anywhere on or be-
tween EX SMALL (a few small items)
and EX LARGE (a full load).
NOTE: Use the EX LARGE water
level for best permanent press
results.
l Match the wash and rinse water
temperature to the type of fabrics and
soils being washed.
* All rinses are cold. Cold rinses save
energy and help prevent wrinkles from
setting into fabrics,
Recommended wash temperatures
can be found in your “Laundry Guide!’
I : .i *Fitaem
LOAD SIZES AND WATER LEVELS T.
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items. OVERLOAD WASHER. ;
*Approximate
fill with load. (21.7 galJ82.1 L)* !
(18.3 galJ69.3 L)* J
(15.0 galI56.8 L)* j
(11.9gal./450 L)’ ;
4

3. Start the washer
A. Push in the Control Knob and turn
it to the right. It must be pushed in
and turned only clockwise.
C. Start the washer by pulling out
the Control Knob. The washer will
fill to the level you set with wash
water of the selected temper-
ature. After filling, the washer will.
agitate for the selected number
of minutes,
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows 10 minutes of agitation in
the REGULAR NORMAL Cycle.
D. To stop the washer at any time,
push in the Control Knob. To
restart the washer, pull out the
Control Knob.

What Happens in Each Cycle*
Each cycle has different agitation and spin speeds designed for different
kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH
agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer fills
before agitation and timing starts. After agitation starts, the knob turns clock-wise
until it points to OFF and the cycle ends.
REGULAR HEAVY Cycle
A cycle for sturdily con-
structed fabrics that are
heavily soiled.
REGULAR NORMAL Cycle
A cycle for regular loads
of fabrics that are moder-
ately soiled.
PERMANENT PRESS NORMAL Cycle
A cycle designed for mod-
erately soiled permanent
press and some synthetic
fabrics. The cool-down
rinse helps keep wrinkles
from setting into these
items.
6
WASH
6
Minutes
Low
Speed
WASH
‘L
Min6utes
LOW
Speed
REFILL
LJ
COOL
DOWN

NOTE: You may hear the sound of water spraying during tI= cnin nn* nf=nma I
cycles. In some cycles, cold water is sprayed on the spinr ,,,,
the rinsing. y 8”“” I” Ivap w*111I
Geniie Wash System
For better fabric care in the REGULAR and PERMANENT PRESScycles, the
agitation speed is reduced during the last few minutes of wash time.
1 DRAIN 1, 1 SPIN FILL 1 1 RINSE 1 1 DRAIN 1 SPIN 1 , 1 SPIN 11

PERMANENT PRESS LIGHT Cycle
A cycle designed for
lightly soiled permanent
press and some synthetic
fabrics. The cool-down
rinse helps keep wrinkles
from setting into these items.
KNITS/GENTLE NORMAL Cycle
rlndlcates the machine is
I 1
A cycle that gently
washes and spins moder-
ately soiled delicate items
and washable knits.
KNITS/GENTLE LIGHT Cycle
pauslng for a brief soak
period.
A cycle that gently
washes and spins lightly
soiled delicate items and
washable knits.
SUPER WASH Cycle
A Indicates the machine is
pausing for a brief soak
period.
s
Use for washing heavily
soiled loads thatrequire
maximum soil removal.
Double the amount of
detergent recommended
when using the SUPER
WASH Cycle.

The washer will proceed to the
REGULAR/HEAVY Cycle. If you
want a different cycle to follow
SUPERWASH, push in the cycle
control knob, turn to the cycle and
time you want, pull knob out to
start.

Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra detergent
can require an extra rinse.]
1. Push Control Knob in.
2. Turn clockwise to any l on the dial.
See above drawing.
3. Pull Control Knob out. The washer
will fill to selected level; agitate 2
minutes; drain and spin.
Your washer can be set to drain and
spin out water.
1. Push Control Knob in.
2. Turn clockwise to the bar just before
the OFF area in any cycle. See
above drawing.
3. Pull Control Knob out. The washer
will drain and spin.
For agitation and spin speeds in each cycle, see pages 6-9.
MAGIC CLEAN@ lint filter
The lint filter in your washer cleans itself. Collected lint is
drained away with the wash and rinse water.
If your washer drains into a tub, remove any lint collected
in the drain or strainer.
10

Caring for your wa
Isher
WHEN NOT WASHING, keep both
water faucets turned off, this takes the
pressure off the water inlet valve and
hoses.
REMOVE SHARP OBJECTS such as
pins, buckles, etc., from clothes before
washing. Close metal zippers.
AFTER WASHING, use a soft dry cloth tc
wipe the outside and inside dry. Leave
the lid up until the basket is dry. Wipe
up spills right away. Spills can dull or
damage the finish.
SHARP OR HEAVY OBJECTS should
never be put on or in the washer.
Check pocket for bolts, nuts, tools, etc.
SOME PRETREATMENT PRODUCTS can
damage washer and dryer dials, con-
soles and finishes. Do not use these
products on or near your washer or
dryer.
11

Winterizing
Because some water stays in the washer, freezing
can cause a lot of damage. If your washer is
stored or moved during the cold weather...
1. Shut off both water 2. Put a quart of R.V
faucets. Disconnect or automobile type
and drain water antifreeze in the
inlet hoses. basket.
3. Set the washer for a
DRAIN and SPIN (see
page IO]. Let it run
for about 30 seconds
to mix the antifreeze
and water.
To use the washer again...
I. Flush water pipes and hoses.
2. Connect hoses to the washer
3. Turn on the water faucets.
4. Run the washer
through a com-
plete cycle with
one cup of deter-
gent to clean out
the antifreeze.

If you need
we suggestIservice or assistance,
YOUfollow these five steps:
1. Before calling for
assistance... -
Performance problems often result
from little things you can find and fix
yourself without tools of any kind.
if your washer does not fill:
l Is the power supply cord plugged
into a live circuit with the proper
voltage?
l Are both water faucets open?
l Have you checked your home’s
main fuses or circuit breaker box?
l Are the water supply hoses kinked?
l Is the Cycle Control Knob set and
pulled out?
if your washer does not spin:
l Is the lid closed?
l Is the power supply cord plugged
into a live circuit with the proper
voltage?
l Have you checked your home’s
main fuses or circuit breaker box?
if your washer stops during a cy
l Remember, the washer pauses
briefly at different times in each
cycle. These pauses are normal.
if your washer fills and drains
without running:
l Make sure that the Cycle Control
Knob is pointing to a number in the
cycle.
Make sure the drain hose is higher
than the water level in the washer.
if it isn?:
l The washer may seem to be drain-
ing during wash and rinse cycles.
l Water can siphon out. (See “lnstalla-
tion Instructions:‘)

2. If you moved...
To make sure that your appliance is
correctly installed and to insure its
continued satisfactory operation, call
your dealer. (Installation cost must, of
course, be paid by you.)
3. Helpful hints...
You can help your service represent-
ative give faster service if you include
the model and serial number of your
appliance when requesting service.
Also, retain yoursales slip and warranty
to verify your warranty status.
Remember-Your service represent-
ative is trained in repairing and servic-
ing your Whirlpool appliances. He can
help you maintain the quality origi-
nally built into your WHIRLPOOL ap-
pliance. So...take the time now to look
up his telephone number and jot
it down in the space provided on
page 2.
4. If you have a
problem?..
Call your dealer or write:
Manager,
International Consumer Affairs
Whirlpool Corporation
Administrative Center
2000 M-63
Benton Harbor, Michigan 49022
5. If you need FSP” *
replacement parts...
FSP is a registered trademark of
Whirlpool Corporation for quality
parts. Look for this symbol of quality
whenever you need a replacement
part for your Whirlpool appliance. FSP
replacement parts will fit right and
work right, because they are made to
the same exacting specifications
used to build every new Whirlpool
appliance.
‘If you must call or write, please pro-
vide: model number, serial number,
date of purchase, and a complete
description of the problem. This infor-
mation is needed in order to better
respond to your request for
assistance.
14

Notes

WHIRLPOOL” AUTOMATIC WMHER
WARRANTY
LENGTH OF WARRANTY 1 WHIRLPOOL WILL PAY FOR
FULL ONE-YEAR
WARRANTY
From Date of Purchase
FSP@replacement parts and repair labor to
correct defects in materials or workmanshlp.
Service must be provided by a franchised
TECH-CAREa service company
LIMITED FIVE-YEAR
WARRANTY
From Date of Purchase
LIMITED TEN-YEAR
FSPreplacement of outer tub should it crack,
WARRANTY
or fail to contain water, due to defective
From Date of Purchase materials or workmanship.
WHIRLPOOL WILL NOT PAY FOR
FSPreplacement parts for any part of gear-
case assembly if defective in materials or
workmanship. The gearcase assembly is
shown below.
A. Service calls to:
1. Correct the installation of the washer.
2. Instruct you how to use the washer.
3. Replace house fuses or correct house wiring or plumbing.
B. Repairs when washer is used in otherthan normal, single-family
household use.
C. Pick up and delivery. This product is designed to be repaired in
the home.
D. Damage to washer caused by accident, misuse, fire, flood, acts
of God or use of products not approved by Whirlpool.
E. Anv labor costs durina the limited warranties.
WHIRLPOOLCORPORATION SHALLNOT BELIABLEFORINCIDENTAL OR CONSE-
QUENTIALDAMAGES, Some states do not allow the exclusion or limitation of
incidental or consequential damages so this limitation or exclusion may
not apply to you. This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
Outside the United States, a different warranty may apply. For details, please
contact your franchised Whirlpool distributor or military exchange.
GEARCASE ASSEMBLY
COVERED BY YOUR
WARRANTY
Whirlpool
Part No. 3349149
01987 Whirlpool Corporation Printed in U.S.A.