Whirlpool LA543oxs User manual

c
AUTOMATIC
WASHER
Large Capacity
Model
LA543oxs
Anwave Ovens. Trash Compactors. Room AM Condllloners. Dehumldifws, Automatic Washers, Clolhes Dryers, Freezers, Refrlgeralor-

Contents
Page
PARTS AND FEATURES 2
IMPORTANT SAFETY
INSTRUCTIONS. . 3
OPERATING INSTRUCTIONS.. 4
Starting Your Washer 4
What Happens in Each Cycle 6
OTHER OPERATING
INSTRUCTIONS 10
I
For a Rinse and Spin
For a Drain and Spin
Cleaning the Lint Filter .
CARING FOR YOUR WASHER
Winterizing
IF YOU NEED SERVICE OR
ASSISTANCE
WASHER WARRANTY
Page
10
10
10
11
12
13
16
01987 Whirlpool Corporation
Parts and features
LOAD LAUNDRY CYCLE
SIZE INFORMATION CONTROL LINT FILTER
SELECTOR
. / CENTER , KNOB (not shown)
EMPERATURE
SELECTOR
ODE1 AND SERIAL
NUMBERPLATE
washer is used.
You should wipe out the
basket with a damp cloth
before using to remove dust
1 from storing or shipping.
Copy your Model and Serial Numbers here
When you need service or call with a
question, have this information ready:
1. Complete Model and Serial Numbers
Model Number
(from plate under the lid near the
hinge]. serio, Number
2. Purchase date from sales slip.
Copy this information in these spaces. Purchase Date
Keep this book, your “Laundry Guide” and
sales slip in the Laundry Information
Center.
Service Company
Phone Number
Please complete and mall the Owner Registration Card furnlshed wllh
this product.
2

Additional Safety Instructions and Your Responsibilities
ALWAYS store detergent, laundry aids ALWAYS unplug the power supply
and other materials in a cool, dry cord before attempting to service the
place where children can’t reach washer.
them- in a locked cabinet if possible. DO NOT machine wash glass fiber
ALWAYS read and follow instructions materials. Small particles can stick to
on packages of detergent and laun- fabrics washed in following loads
dry aids - especially warnings and and cause skin irritation.
precautions. You are personally responsible for
HAZARDOUS FUMES can be formed if making sure that your washer:
chlorine bleach is used in the same
l is used only for jobs normally ex-
wash as ammonia or acids such as
vinegar or rust remover. petted of home automatic washers.
l is not run by children or anyone un-
able to operate it properly. 3

Operating instructions
Starting Your Washer
Be sure to measure and add detergent, then place
a sorted load in the washer before starting it.
1
. Select a LOAD SIZE
2
Select
. WATER TEMPERATURES
l Turn the knob to point at a setting
that describes the size of load you
want to wash.
l The water level can be set for
SMALL (a few items] or LARGE
(a full load].
NOTE: Use the LARGE water level
for best permanent press results.
l Match the wash and rinse water
temperature to the tvpe of fabrics and
soils being washed.
l All rinses are cold. Cold rinses save
energy and help prevent wrinkles from
setting into fabrics.
Recommended wash temperatures
can be found in your “Laundry Guide.”
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or 0
CAUTION:
DO NOT
OVERLOAD WASHER.
tearing of load items.
*Approximate LARGE (17.3 gals./655 L)’
fill with load. SMALL (9.5 galsJ36.0 L]*
4

i TIME;
B. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows 6 minutes of agitation in
the REGULAR NORMAL Cycle.
D. To stop the washer at any time,
push in the Control Knob. To
restart the washer, pull out the
Control Knob.

What Happens in Each Cycle*
Each cycle has been designed for different kinds of fabrics. Numbers on the
dial on each cycle are the minutes of WASH agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer fills
before agitation and timing starts. After agitation starts, the knob turns clock-wise
until it points to OFF and the cycle ends.
REGULAR HEAVY Cycle
A cycle for sturdily con-
structed fabrics that are
heavily soiled.
REGULAR NORMAL Cycle
.-
A cycle for regular loads
of fabrics that are moder-
ately soiled.
PERMANENT PRESS NORMAL Cycle
A cycle designed for mod-
erately soiled permanent
press and some synthetic
fabrics. The cool-down
rinse helps keep wrinkles
from setting into these
items.
nn

NOTE: You may hear the sound of water spraying during the spin parts of some
cycles. In some cycles, cold water is sprayed on the spinning load to help with
the rinsing.

PERMANENT
PRESS
A cycle designed for
lightly soiled permanent
press and some synthetic
fabrics. The cool-down
rinse helps keep wrinkles
from setting into these items.
SHORT Cycle
Alndlcates the machine is
Use for delicate items that
need a short wash and spin
time. Wash nylon hose or
panty hose in a net laundry
bag.
pauslng for a brief soak
period.
8

Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and Your washer can be set to drain and
spin for heavily soiled loads which spin out water.
need more detergent. (Extra detergent 1. Push Control Knob in.
can require an extra rinse.]
1. Push Control Knob in.
2. Turn clockwise to any o on the dial.
See above drawing.
3. Pull Control Knob out The washer
will fill to selected level; agitate 2
minutes; drain and spin.
2. Turn clockwise to the bar just before
the OFF area in any cycle. See
above drawing.
3. Pull Control Knob out. The washer
will drain and spin.
Cleaning the lint filter
Clean filter after every load for
best filtering results. NOTE: The load
type will vary the amount of lint
build-up.
To clean:
1. Lift off the agitator barrel.
2. Wash or wipe the filter clean in
the bottom of the agitator barrel.
The filter is not removable.
3. Replace the agitator barrel and
snap into place.
IO

Caring for your washer
WHEN NOT WASHING, keep both AFTER WASHING, use a soft dry cloth to
water faucets turned off, this takes the wipe the outside and inside dry. Leave
pressure off the water inlet valve and
hoses. the lid up until the basket is dry. Wipe
up spills right away. Spills can dull or
damage the finish.
REMOVE SHARP OBJECTS such as
pins, buckles, etc., from clothes before
washing. Close metal zippers.
SHARP OR HEAVY OBJECTS should
never be put on or in the washer.
Check pocket for bolts, nuts, tools, etc.
SOME PRETREATMENT PRODUCTS can
damage washer and dryer dials, con-
soles and finishes. Do not use these
products on or near your washer or
dryer.

Winterizing
Because some water stays in the washer, freezing
can cause a lot of damage. If your washer is
stored or moved during the cold weather...
1. Shut off both water 2. Put a quart of
faucets. Disconnect automotive-type
and drain water antifreeze in the
inlet hoses. basket.
3. Set the washer for a
DRAIN and SPIN (see
page 10).Let it run
for about 30 seconds
to mix the antifreeze
and water.
ON
To use the washer again...
1. Flush water pipes and hoses.
2. Connect hoses to the washer
3. Turn on the water faucets.
4. Run the washer
through a com-
plete cycle with
one cup of deter-
gent to clean out
the antifreeze.
12

If you need service or assistance,
we suggest you follow these five steps:
1. Before calling for
assistance...
Performance problems often result
from little things you can find and fix
yourself without tools of any kind.
If your washer does not fill:
l Is the power supply cord plugged
into a live circuit with the proper
voltage?
l Have you checked your home’s
main fuses or circuit breaker box?
l Are the water supply hoses kinked?
l Is the Cycle Control Knob set and
pulled out?
If your washer does not spin:
l Is the lid closed?
l Is the power supply cord plugged
into a live circuit with the proper
voltage?
l Have you checked you home’s
main fuses or circuit breaker box?
If your washer stops during a cycle:
l Remember, the washer pauses
briefly at different times in each
cycle. These pauses are normal.
If your washer fills and drains
wlthout running:
l Make sure that the Cycle Control
Knob is pointing to a number in the
cycle.
Make sure the dmin hose Is higher
than the water level in the washer.
If it isnV:
l The washer may seem to be drain-
ing during wash and rinse Cycles.
l Water can siphon out. (See “InStalla-
tion Instructions?)
l Are both water faucets open?

2. If you need
assistance;k...
Call Whlrlpool COOL-LINE@ serv-
Ice assistance telephone number.
Dial free from anywhere in the U.S.:
I-800-253-1301
and talk with one of our trained Con-
sultants. The Consultant can instruct
you in how to obtain satisfactory
operation from your appliance or, if
service is necessary, recommend a
qualified service company in your
area.
3. If you need service?. .
Whirlpool has a
nationwide network
of franchised TECH-
CARE@ Service Com-
panies, TECH-CARE
service technicians
are trained to fulfill the product
warranty and provide after-warranty
service, anywhere in the United States.
To locate TECH-CARE service in your
area, call our CCCL-LINE service assis-
tance telephone number (see Step 2) or
look in your telephone directory Yellow
Pages under:
4. If you have a
problem%..
Call our COOL-LINE service as-
sistance telephone number (see Step
2) and talk with one of our Consultants,
or if you prefer, write to:
Mr. Robert Stanley
Division Vice President
Whirlpool Corporation
2000 M-63
Benton Harbor, Ml 49022
5. If you need FSP”
replacement part&.
FSP is a registered trademark of
Whirlpool Corporation for quality
parts. Look for this symbol of quality
whenever you need a replacement
partforyour Whirlpool appliance. FSP
replacement parts will fit right and
work right, because they are made to
the same exacting specifications
used to build every new Whirlpool
appliance.
‘If you must call or write, please pro-
vide: model number, serial number,
date of purchase, and a complete
description of the problem. This infor-
mation is needed in order to better
respond to your request for
assistance.
14

15

WHIRLPOOL” AUTOMATIC WASHER
WARRANTY
LENGTHOF WARRANTY
FULLONE-YEAR
WARRANTY
From Date of Purchase
WHIRLPOOL WILL PAYFOR
FSP@replacement parts and repair labor to
correct defects in materials or workmanship.
Service must be provided by a franchised
TECH-CARE” service company.
LIMITED FIVE-YEAR
WARRANTY
From Date of Purchase
FSP replacement parts for any part of gear-
case assembly if defective in materials or
workmanship. The gearcase assembly is
shown below.
LIMITED TEN-YEAR FSPreplacement of outer tub should it crack,
WARRANTY or fail to contain water, due to defective
From Date of Purchase materials or workmanship.
WHIRLPOOL WILL NOT PAYFOR
A. Service calls to:
I. Correct the installation of the washer.
2. Instruct you how to use the washer.
3. Replace house fuses or correct house wiring or plumbing.
B. Repairs when washer is used in other than normal, single-family
household use.
C. Pick up and delivery. This product is designed to be repaired in
the home.
D. Damage to washer caused by accident, misuse, fire, flood, acts
of God or use of products not approved by Whirlpool.
E. Any labor costs during the limited warranties.
WHIRLPOOL CORPORATION SHALL NOT BELIABLE FOR INCIDENTAL OR CONSE-
QUENTIAL DAMAGES. Some states do not allow the exclusion of limitation of
incidental or consequential damages so this limitation or exclusion may
not apply to you. This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
Outside the United States, a different warranty may apply. For details, please
contact your franchised Whirlpool distributor or military exchange.
GEARCASE ASSEMBLY
COVERED BY YOUR
WARRANTY
Part No. 3349118
01987 Whirlpool Corporation
Printed in U.S.A.