Whirlpool LA553OXP User manual

\
\
AUTOMATIC
WASHER
Design 2000
~oW~,CaPW
LA553OXP
law Ovens. Trash Compactors. Room AM Candllloners. Oehumldlllers. Automatic Washers, Clothes Dryers. freezers. Refrqerator-Freeze

Parts and features
LAUNDRY TEMPERATURE
InAn
L”tTY
‘WFORMATION
SIZE ” SELECTOR
CENTER 1 CYCLE
\
YcKzBoL
)
- -
MAGIC CLEAN@
LINT FILTER
(not shown)
LIQUID BLEACH
DISPENSER
MODEL AND SERIAL
- NUMBER PLATE
[not shown)
- AGITATOR
- BASKET
- TUB
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
Copy your Model and Serial Numbers here
When youneed service or call with a
question, have this information ready:
Model Number
1. Comolete Model and Serial Num-
bers (irom plate under the lid near the
hinge].
Serial Number
2. Purchase date from sales slio
Copy this information in these spaces. Purchose Date
Keep this book in the Laundry Informa-
tion Center with your”Laundry Guide:’ Service ComDonv/
sales slip and warranty.
Phone Number
There is no warranty registration to return. Proof-of-purchase is all
that is required for in-warranty service.
2

re
Read this “Use and Care Guide”
and your “Laundry Guide” care-
fully for important use and safety
information.
You are personally responsible
for making sure that your
washer...
l is installed by a qualifiedinstaller.
l is properly installed and
leveled on a floor that can
support the weight.*
l is connected to the right kind
of outlet, electric supply, water
supply and drain.’
l is properly grounded.’
l is used only for jobs normally
expected of home automatic
washers.
l is properly maintained.
l is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l is not run by children or anyone
unable to operate it properly.
*See the”Installation Instructions”
for complete information.
Contents
Page
PARTS AND FEATURES 2
YOUR RESPONSIBILITIES. 3
SAFETY FIRST. 3
STARTING YOUR WASHER. 4
WHAT HAPPENS IN EACH
CYCLE 6
OTHER OPERATING
INSTRUCTIONS. 10
For a Rinseand Spin 10
For a Drain and Spin 10
ForaSoakorPre-Wash 10
Liquid Bleach Dispenser 11
MAGIC CLEAN” Lint Filter 11
CARING FOR YOUR WASHER. 12
Winterizing 13
IF YOU NEED SERVICE OR
ASSISTANCE.. 14
1. Before Calling for
Assistance 14
2. If You Need Assistance. 15
3. If You Need Service 15
A. If You Have a Problem 15
01985 Whirlpool Corporation -SAVE THESE INSTRUCTIONS - 3

Starting your washer
Before starting your washer: I. Measure and add detergent
2 Place sorted load In washer
3 Start washer
Select a
1. LOAD SIZE Select WATER
2. TEMPERATURES
. Turn the knob to point at a setting 9 Match the wash water
tc?mperOtUrf?
that describes the size of load you to the type of fabrics and solIs being
want to wash. washed.
l Set the knob anywhere on or be-
tween EX SMALL (a few Items) and
LARGE (a full load).
l All rinses are cold
Recommended wash temperatures
can be found in your “Laundry Guide.”
I
NOTE: Use the LARGE water level
for besl permanent press results.
LOAD SIZES AND WATER LEVELS
for best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
0
DO NOT
little water can cause wear or OVERLOAD WASHER.
tearing of load items.
*Approximate
fill with load.
(17.3 gals./655 L)*
(14.7 gals./557 L)’
(12.1galsJ45.8 L)’
EX-SMALL (9.5 gals./36.0 L)’
4

3. Start the washer
A. Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise
6. Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows10 minutes of agitation in
the REGULAR Cycle.
C. Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes
D. To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
5

What happens in each cycle*
Each cycle has different agitation and spin speeds designed for different
kinds of fabrics. Numbers on the dial in each cycle are the minutes of WASH
agitation time.
When the Cycle Control Knob is set to a number and pulled out, the washer
fills before agitation and timing starts. Afler agitation starts, the knob turns clock-
wise until it points to OFF and the cycle ends.
REGULAR HEAVY Cycle
REGULAR Cycle
A cycle for sturdily con-
structed fabrics that ore
heavily soiled.
A cycle for regular loads of
fabrics that are moderately
soiled.
PERMANENT PRESS Cycle
A special cycle with the
necessary cool down rinse
which helps keep wrinkles
from setting into Permanent
Press and some synthetic
fabrics.
6

NOTE: You may hear the sound of water spraying during the spin parts of
some cvcles. In some cycles, cold water is sprayed on the spinning load to help
with the’rinsing
PARTIAL DRAIN
DRAIN No
(Pause) Agltatbn

KNITS/GENTLE Cycle
A cycle for lightly soiled
items that need a short
wash and spin time. Wash
nylon hose in a net laundry
bag.
,
S0.4K .4ND PRE-WASH Cycles
Brief periods of agitation
detergent or pre-soak
additive. The SOAK Cycle
should always be fol;
lowed by a Wash Cycle.
DO NOT LOAD
ABOVE CLOTHES GUARD

I
+Pre-wash setting begins here, (see pagelo).
Special care is needed when soaking or pre-washing laundry
See your “Laundry Guide” for proper use of this cycle. 4
9

Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and Your washer can be set tp drain
spin for heavily soiled loads which and spin out water.
need more detergent. (Extra de-
l Push Control Knob in.
tergent can require an extra rinse.)
l Turn clockwise to the bar just before
l Push Control Knob in. OFF In any cycle. See above
l Turn clockwise to any.on the dial drawing.
See above drawing.
l Pull Control Knob out.
l Pull Control Knob out. . The washer WIII drain
OndSpln
l The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For agitation and spin speeds in each cycle, see pages 6- 9
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing stalned
laundry. Hot water can set stains.
l Use recommended amount of
detergent or pre-soa k product.
l Push Control Knob in.
l Turn clockwise to point at a number
in the SOAK Cycle...use the 6-minutes
mark for a pre-wash:
l Pull Control Knob out to start washer.
l When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
intormation on page 7 of your
“Laundry Guide!’
l Set the washer and start the next
selected wash cycle.
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.