Wholesale Beds Panama Coffee Table User manual

Panama Coffee Table
ASSEMBLY INSTRUCTIONS
IMPORTANT
PLEASE READ BEFORE YOU CONTINUE FURTHER
CARE AND MAINTENANCE
After unpacking this product please keep the original packaging in case it needs to be
returned for any reason.
• Please ensure all fittings and parts are present before commencing with assembly.
• We recommend that you lay a blanket or sheet on the floor to avoid damage to both your
floor and the product.
• We strongly recommend that you keep children away from your work area.
• Assemble this product as close to its final position as possible.
• Never drag or push products as this could cause damage to the joints making it inferior.
• Do not place this product next to a radiator or in direct sunlight.
• Wood is a natural product and may expand if subjected to damp and may shrink or crack
if subjected to heat. Therefore it is recommended that room temperature is maintained,
with no sudden temperature fluctuations.
• Make sure any spillage is wiped off immediately.
• Do not place hot or chilled items directly on to the surface, use a place mat or marking
will occur.
• For general cleaning use a duster, and do not use detergents of any kind. However, the
surface will need to be retreated from time to time. This can be done by using block wax
(unperfumed) and rubbing it over the whole item.
• From time to time it may be necessary to tighten fittings, regular inspections should be
carried out.
Page 1
50505(MY)
SEC/WG/08/17/MY1
FOR DOMESTIC USE ONLY

* Please check contents and read the instructions before commencing assembly.
* Assemble this product following the enclosed instructions carefully.
* Please take care to avoid damaging panels during assembly.
* Use of power tools to assemble this product will invalidate
any claim and damage this product making it unsafe !!!
* Please assemble on a clean soft surface to avoid damage.
FITTINGS
PARTS LIST
Page 2
Ø 3,5 x 35mm
Ø 8 x 30mm
C
B
A
08
30
34
Ø 3,0 x 30mm
E 01
D 01
Back panel
Front frame
Top panel
Leg
Drawer side
Drawer bottom
1
2
3
3
4
4
4
4
5
8
9
9
10
11
6
7
Right drawer runner
Drawer back
Side panel
Left drawer runner
Drawer front
M4 x 25mm
SEC/WG/08/17/MY1

01
Please assemble on
a clean soft surface
to avoid damage.
Ø 8 x 30mm
A32
A
A
A
A
A
AAA
A
A
A
A
A
A
A
A
AA
A
A
A
A
AA
AA
1
2
3
2x
6
7
A
A
02
03
B
B
B
B
B
B
B
B
B
B
B
B
B
Ø 3,5 x 35mm
B 06
Ø 3,5 x 35mm
B 08
B
B
1
1
2
4
4
4
4
3
3
6
7
Please assemble on
a clean soft surface
to avoid damage.
Please assemble on
a clean soft surface
to avoid damage.
Page 3
SEC/WG/08/17/MY1

04
Ø 3,5 x 35mm
B 06
B
B
B
B
B
B
2
05
Ø 3,5 x 35mm
B 10
B
BB
B
B
B
B
B
B
B
5
Please assemble on
a clean soft surface
to avoid damage.
06
C
C
C
C
C
C
C
D
E
M4 x 25mm
E 01
C08
Ø 3,0 x 30mm
D 01
8
9
9
10
11
Ø 8 x 30mm
A 02
A
A
A
07
Page 4
SEC/WG/08/17/MY1