Widex 6272 User manual

6200
QG_6272_V.1.1_06/16
TECHNICAL SUPPORT
Tel: [phone]
Fax: [phone]
Email: [email protected]
Web: www.videxuk.com
beep!
beep!
6272
Colour Screen Videophone
QUICK GUIDE
OVERVIEW RECEIVING A CALL
OPEN THE DOOR
ART. 6272
6200 Series Videophone incorporating a 3.5” Hi-Res full colour active matrix
LCD monitor specic for the "6 Wire Bus" 2200 Digital System.
It includes 4 buttons: "camera recall", "door open" and 2 "service"buttons.
2 LEDs indicate the privacy is activated and door open.
Programmable number of rings (3 or 6) with up to 9 melodies.
Adjustments: call tone volume (2 levels) and privacy switch. Picture hue,
contrast and brightness controls.
During a call
During a
conversation
To answer an incoming call pick up the handset.
Press the lock button to
open the door.
The LED behind the lock
symbol will
illuminate to indicate that
the door is open (if the DOL
terminal was connected
during the installation).
Door Open button
Service button 1
Door Open LED
Brightness Display adjustment
Call Tone Volume adjustment
& Privacy switch
Camera Recall button
LCD Colour Screen Handset
Service button 2
Privacy LED

zZz
zZz
zZz
zZz
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
zZz
zZz
beep!
beep!
SERVICE BUTTONS
PRIVACY FUNCTION
CAMERA RECALL
When the
system is in
standby
When the
system is in
standby
CALL TONE VOLUME ADJUSTMENT BRIGHTNESS DISPLAY ADJUSTMENT
During a call, a
conversation or in
camera recall mode
In every
situation
In every
situation
During an incoming
call, with the privacy
switch ON, the
videophone will not
ring and no picture
will be displayed.
To set up the function of the service buttons, please
contact Videx Technical.
Move the privacy switch to the left (towards the privacy
symbol ) to enable the privacy function. The LED
behind the privacy symbol will illuminate to
indicate that the privacy function is switched ON.
To switch OFF the privacy function and enable the
call tone, move the privacy switch back to the right
(towards the call tone level symbol ). The privacy
function will be disabled and the call tone enabled.
When the conversation
time (set up during the
installation) has ended,
the videophone stops
all communication and
the system returns to the
standby condition.
Push the required service button or to
activate the secondary service (if this was set up during
the installation).
Pick up the handset and then push the camera recall
button as many times as the ID value of the door
panel (e.g. if recalling the picture from door ID 2, press this
button twice, for door ID 3 press this button 3 times etc.).
The videophone display will show the picture from the
camera on the relevant outdoor station recalled.
Move the switch, under the call tone symbol to
adjust the call tone volume level. Move to the centre
for a low call tone level and to the right for a high call
tone level.
Turn the roller under the brightness control symbol
to adjust the brightness of the picture. Any
adjustment to the left will reduce the brightness and
any adjustment to the right will increase the brightness.
During 'Camera Recall' it is possible:
To start a conversation;
To push the lock button to open the door;
To push the service button or to activate
the relevant secondary service.
Hang up the handset to end the conversation.