Wilbur Curtis N05 User manual
N05
Thanks for using our wireless electronic products. For a good user experience, please
read the manual carefully before using the products. Notice: To avoid unnecessary troubles,
please do not disassemble these products by yourself, and please use the standard charger
to charge.
SCAN ME
www.iwilbur.com
Choose the ear cap
that suits you.
demonstration
Error
Gently rotating the earbuds
to a comfortableposition.
Put the earbuds into the
ear in the
angle shown as
the
picture above.
ON
OFF
●The earbuds will automatically turn on after
opening the top lid of the charging case.
OR
●Press and hold the power switchfor 5s then
stop to hold, the earbuds will turn on.(Not in the
charging compartment and is in the off state)
●
Put the earbudsinto the charging case and
close
the lid, they will automatically
shut down.
OR
●
While in the non-working state, press and
hold the
power switch
for 5s, the two earbuds
will be turned off at the same time.
OR
●
Automatically shut down after not connected
for more than 10 minutes
In a non-calling state, click the MFB button once on the left earbud to switch the following
modes in turn.
ANC Active Noise Cancelling (TWS state)
Turn on ANC mode Turn off ANC mode
Turn on
Transparent mode
2x
1x
3x
2x
3x
4x
Accept Decline
Reject
Previous
track Next track
Volume- Volume+
Play/Pause
Voice assistant
1x
ANC
TWS state
Switch ANC
Warm notice
For any single earbud, when it is in standalone mode, you can’t
use it to play the previous song or decrease the volume.
First time using
Red& White
Flash
1
3
2
Indicator off
Tear off the insulating film. Put the earbuds into the charging case
and close the lid tocharge(the earbuds are in charging state).
Open the cover of the charging case and, they will turn on
and pair automatically
and will be prepared for pairing to the
phone(the indicator will turn to Red and white
alternately).
The indicator of one
earbud will go off
and
another will flash red
and white light
alternately
.
(In pairing mode)
Gentle Tips: For two unpaired earbuds and no device is
connected also at
the meanwhile, three-click the left/right
earbuds after turning on to enter the
TWS pairing state, the white light flashes quickly; when pairing is successful,
the red and white flashes alternately.
Note: Nothing need to do if the earbuds are paired and connected.
Settings Bluetooth
N05
Bluetooth
Now discoverable as”Qi iPhone”.
MYDEVICES
To pair Apple Watch with your iPhone, go to the
Watch app.
Red& White
Flash
3x
4
12
Red& White
Flash
Indicator off
Turn on the Bluetooth function on
your phone and search for【N05】
and connect it.
Restore factory setting
1.When the earbuds are turned on and not connected to the cell
phone, quickly touch the left and right earbuds buttons 5 times at
the same time, the red light will be on for 1 second, then the
earbuds clear the memory and shut down automatically .
5x
Settings Bluetooth
N05
Bluetooth
Now discoverable as”Qi iPhone”.
MYDEVICES
To pair Apple Watch with your iPhone, go to the
Watch app.
Bluetooth
Forget This Device
N05
Device Type
Forget Device
cancel
L&R Earbud
2.Please delete all paired records on the phone and search
again for "N05"on the bluetooth of mobile phone and reconnect.
Table of contents
