Wine Rack Shop 3Bx3Bx7RTOPBASE User manual

Assembly Instructions for 42 Bottle Corner Wine Rack
Step 1. Align all rack uprights with ends marked “B” at the same end. This end of rack uprights is the bottom of
the rack and will sit on the baseboard unit.
Step 2. Insert bolt through pre-drilled lowest(1st)rack upright hole and pre-drilled shelf hole. Hand-tighten nut on
inside of shelf. Skip 3 holes between each bolt and repeat Step 2 for all seven shelves. Do this for all 4 rack
uprights.

Step 3. Repeat shelf assembly in step 2 with 2nd rack until you have 2 completed racks.
Step 4. Where racks butt against each other in rear, place rack attachment piece between two shelves and attach to rack
uprights using nuts and bolts. Your rack may require more than one attachment piece.

Step 5. Attach two rack top pieces together. Insert wood screws through top attachment piece and into pre-drilled holes in
top and tighten with screwdriver.
Step 6. Attach two baseboard pieces together. Insert wood screws through baseboard attachment piece and into pre-drilled
holes in baseboard piees and tighten with screwdriver.

Step 7. Once all shelves are fastened with bolt and nut, stand both racks on rack uprights ends marked with “B”. Use Allen
wrench and tighten bolts completely. Bolt heads should sink slightly into wood rack uprights. Slide both racks onto
baseboard unit. Slide rack top over rack uprights and onto racks.
Step 8. Add wine to your rack!