Wine Rack Shop Corner Liquor Bottle Rack User manual

Assembly Instructions for Corner Liquor Bottle Rack
Step 1. Align all rack uprights with ends marked “B” at the same end. This end of rack uprights is the bottom of
the rack and will sit on the baseboard unit.
Step 2. Slide both shelf sections together and attach shelf fastener piece using wood screws as shown. Repeat this
step for all three shelves.

Step 3. Insert bolt through pre-drilled rack upright hole and pre-drilled shelf hole. Hand-tighten nut on inside of
shelf. Do this for all five rack uprights. Repeat this step for all three shelves. Note: Shelves can be attached at
any hole position in rack uprights. Tighten all bolts with Allen wrench.
Step 4. Slide both rack top sections together and attach rack top fastener piece using wood screws as shown.

Step 5. Slide both baseboard sections together and attach baseboard fastener piece using wood screws as shown.
Step 6. Place assembled baseboard on level floor and set rack onto baseboard. Slide assembled rack top over rack uprights
and down onto rack uprights.

Step 6. Add bottles to your rack!